|
|
|
#1
|
||||
|
||||
SDL air cleaner nut size?
Was swapping out my air filter, and I had the nuts in the tray cap. Of course, when I went to bolt it all back up (butterfingers!) dropped the tray, and down the sewer grate it all went.
So, does anyone know what size nut I need to replace them? I think these were flanged 12mm, but I could be off base. I had some 13mm, but too big. 11mm too small. Jeeze is it even metric or some special MB sizing thing... Any help is appreciated.
__________________
Ethan Hunter 1986 Mercedes-Benz 300SDL (263,000 miles) |
#2
|
||||
|
||||
It will be metric... at a guess M6 coarse thread... go for the correct thread size not the outer hex size.
Alternatively get a magnet and go fishing.
__________________
1992 W201 190E 1.8 171,000 km - Daily driver 1981 W123 300D ~ 100,000 miles / 160,000 km - project car stripped to the bone 1965 Land Rover Series 2a Station Wagon CIS recovery therapy! 1961 Volvo PV544 Bare metal rat rod-ish thing I'm here to chat about cars and to help others - I'm not here "to always be right" like an internet warrior Don't leave that there - I'll take it to bits! Last edited by Stretch; 04-23-2013 at 04:15 AM. Reason: Added a bit |
Bookmarks |
|
|