|
|
|
#1
|
|||
|
|||
10mm Mandrel - where can I buy one?
I'm looking to purchase the 10mm Mandrel located on top of page 1033 (Item #10) of the following write up. I believe the size is 10mm X 150mm. Anyone have any ideas where I could purchase one?
http://www.startekinfo.com/StarTek/outside/12253/program/Chassis/41-200.pdf |
#2
|
||||
|
||||
Quote:
__________________
Current Stable
|
#3
|
||||
|
||||
Does anyone think a 10mm Bolt with the threaded end cut off would work?
__________________
84 300D, 82 Volvo 244Gl Diesel |
#4
|
||||
|
||||
Quote:
When I did mine, I looped some heavy wire through the drilled holes and attempted to use a slide hammer...no luck. Use pry bars and it will come right out.
__________________
Current Stable
|
#5
|
|||
|
|||
I wouldn't be too concerned about the 10mm dimension. A piece of 3/8" steel rod, or a 3/8" bolt will do the job just as well. A 3/8" twist drill is also probably easier to find, and cheaper.
__________________
'79 240D |
Bookmarks |
|
|