|
|
|
#1
|
||||
|
||||
Water hose help needed.
Just got off the phone with pelican parts and ordering all new heater hoses for my 85 300TD. 8 total hoses were accounted for, however the hose the runs from the bottom of the reservoir to the bottom of the radiator he said is unavailable.
It's about 3/4 to 1 inch in diameter and 2.5 feet long or so, and is form fitted. What is another source to find it at? Or is it readily available and he is mistaken? Thanks |
#2
|
|||
|
|||
I recall seeing that hose on rock recently, for my 85 300D. I didn't buy because ~$75 and mine looked OK, even better after viewing that price. I was striving to get my cooling perfect before switching to Evans Waterless Coolant, since it is too pricey to afford losing any to a hose. It cost $120 for almost 3 gals, and I had to flush and drain the block and heater core, but I hope corrosion is behind me now, plus I'll never have to change coolant again.
|
#3
|
||||
|
||||
Is this a Hose that could be pieced to gether with a smaller section of generic formed Hose a Barbed Coupling with Barbs on both ends and a Straight Hose and 2 Hose Clamps?
I don't have an 85 so I don't know what your particular hose looks like.
__________________
84 300D, 82 Volvo 244Gl Diesel |
#4
|
|||
|
|||
Keep in mind also that with the Evans, you can run the system at zero pressure, thus preserving what may be an older hose.
__________________
'83 300D, 126K miles. |
#5
|
||||
|
||||
that hose is 1.25 " on one end, and 3/4" on the other... and it's form fitted to go around the fender/radiator support...
I'd go to a pullapart and snag one... I've got a few that are good, pm if you need me to ship one.
__________________
John HAUL AWAY, OR CRUSHED CARS!!! HELP ME keep the cars out of the crusher! A/C Thread "as I ride with my a/c on... I have fond memories of sweaty oily saturdays and spewing R12 into the air. THANKS for all you do! My drivers: 1987 190D 2.5Turbo 1987 190D 2.5Turbo 1987 190D 2.5-5SPEED!!! 1987 300TD 1987 300TD 1994GMC 2500 6.5Turbo truck... I had to put the ladder somewhere! |
#6
|
||||
|
||||
Quote:
My hose does not leak now, I just want to replace all hoses for pre cautionary measures. The way it sounds this hose must seldom go bad? |
#7
|
||||
|
||||
It does not get exposed to as much heat as the other hoses in the system. It does get exposed to pressure but I see these last longer than other hoses.
__________________
1991 F250 super-cab 7.3 IDI. (rebuilt by me) Banks Sidewinder turbo, hydroboost brakes, new IP and injectors. 2003 S430 - 107K 1983 300SD - Tanoshii - mostly restored ~400K+. 1983 300SD - Good interior. Engine finally tamed ~250K. Monark Nozzle Install Video - http://tinyurl.com/ptd2tge |
#8
|
||||
|
||||
I believe this is the hose in question?
123 501 21 82 If so I found it from a few different places...
__________________
Cruise Control not working? Send me PM or email (jamesdean59@gmail.com). I might be able to help out. Check here for compatibility, diagnostics, and availability! (4/11/2020: Hi Everyone! I am still taking orders and replying to emails/PMs/etc, I appreciate your patience in these crazy times. Stay safe and healthy!) 82 300SD 145k 89 420SEL 210k 89 560SEL 118k 90 300SE 262k RIP 5/25/2010 90 560SEL 154k 91 300D 2.5 Turbo. 241k 93 190E 3.0 235k 93 300E 195k |
#9
|
|||
|
|||
I think I bought one recently but haven't installed yet. It wasn't very expensive or I would have ****!! Ask the professor who carries that part number.
__________________
85SD 240K & stopped counting painted, putting bac together. 84SD 180,000. sold to a neighbor and member here but I forget his handle. The 84 is much improved from when I had it. 85TD beginning to repair to DD status. Lots of stuff to do. |
#10
|
||||
|
||||
Thanks for all the replys, you guys make owning a 300 diesel a lot easier.
|
#11
|
||||
|
||||
I would say to get one from URO (it will be the cheapest), but I might get banned for doing so
EDIT: I found one on a competing site, so I can't give the URL. It was a little more than $10, but may be just as bad as URO.
__________________
All Diesel Fleet 1985 R107 300SLD TURBODIESEL 2005 E320 CDI (daily) LOTS of parts for sale! EGR block kit http://www.peachparts.com/shopforum/diesel-discussion/355250-sale-egr-delete-block-off-plate-kit.html 1985 CA emissions 617 owners- You Need This! Sanden style A/C Compressor Mounting Kit for your 616/ 617 For Sale + Install Inst. Sanden Instalation Guide (post 11): http://www.peachparts.com/shopforum/diesel-discussion/367883-sanden-retrofit-installation-guide.html |
#12
|
||||
|
||||
I don't mind paying for quality.
|
#13
|
||||
|
||||
I think it lists at the dealer for about $70 or so.. you could likely find it around there or so.
For hoses and such, I try to stick with either the original equipment manufacturer if there is a consensus on who that is..or Mercedes-Benz.
__________________
Cruise Control not working? Send me PM or email (jamesdean59@gmail.com). I might be able to help out. Check here for compatibility, diagnostics, and availability! (4/11/2020: Hi Everyone! I am still taking orders and replying to emails/PMs/etc, I appreciate your patience in these crazy times. Stay safe and healthy!) 82 300SD 145k 89 420SEL 210k 89 560SEL 118k 90 300SE 262k RIP 5/25/2010 90 560SEL 154k 91 300D 2.5 Turbo. 241k 93 190E 3.0 235k 93 300E 195k |
Bookmarks |
|
|