PeachParts Mercedes-Benz Forum

PeachParts Mercedes-Benz Forum (http://www.peachparts.com/shopforum/)
-   Diesel Discussion (http://www.peachparts.com/shopforum/diesel-discussion/)
-   -   Best way to clean out the A/C evaporator and heater core? (http://www.peachparts.com/shopforum/diesel-discussion/351759-best-way-clean-out-c-evaporator-heater-core.html)

PackerEdgerton 02-28-2014 01:28 PM

Best way to clean out the A/C evaporator and heater core?
 
Hi guys,

I've been searching on this topic, but wanted to get some 'live' advice.

My A/C and heater has a nasty musty smell when in-use. I suspect that the fins on the a/c evaporator and/or the heater cores are probably coated with build-up over the years, just like my other cars.

With the other cars, I have a way to open up the "input" side of the evaporator/heater and gently clean it off, usually with a garden pressure sprayer that has a very dilute mixture of Simple Green and water. I usually finish off with clear water until everything is clear. Works wonders.

What are the options WITHOUT tearing apart the dash and removing the evaporator. I've read the threads on that, and it is way more effort than worth it for just cleaning things.

I have read that people remove the blower assembly and then go in with a sprayer that way. Is that the only method? Best method?

Thoughts?

Thanks,

Packman

eatont9999 02-28-2014 02:42 PM

I can't speak for the W123 but on my W126, I removed the knee bolsters and had access to the evaporator so I could stick a pressure washer wand in there. I used the pressure washer at a manual car wash. First, I soaked the evap in coil cleaner.

Zulfiqar 02-28-2014 04:03 PM

I have used the lubegard evaporator cleaner on a chevy impala and 2 toyota camrys with success. The stuff draining out the evaporator was like ink

PackerEdgerton 02-28-2014 04:23 PM

Quote:

Originally Posted by Zulfiqar (Post 3294264)
I have used the lubegard evaporator cleaner on a chevy impala and 2 toyota camrys with success. The stuff draining out the evaporator was like ink

Hmm. I believe I saw that at the NAPA store. I seems to consist of an aerosol can of foam cleaner where you push it up through the evaporator drain/vent hole of the W123 (just above the tranny) and you just spray it around. It supposedly goes out as a foam and quickly breaks up into a liquid, which then comes back out of the drain hole.

It sounds like a reasonable first approach... but was hoping for something better...

Packman

eatont9999 02-28-2014 05:41 PM

Quote:

Originally Posted by PackerEdgerton (Post 3294274)
Hmm. I believe I saw that at the NAPA store. I seems to consist of an aerosol can of foam cleaner where you push it up through the evaporator drain/vent hole of the W123 (just above the tranny) and you just spray it around. It supposedly goes out as a foam and quickly breaks up into a liquid, which then comes back out of the drain hole.

It sounds like a reasonable first approach... but was hoping for something better...

Packman

Be careful shooting anything up the drain tube. MB used some very soft and brittle foam material that has usually disintegrated by now. You probably don't want a center console full of evap cleaner... To go that route, I would remove the side panel by the radio and shoot the foam in the tube that the drain hose connects to.

lorainfurniture 02-28-2014 11:33 PM

Access through the blower assembly is the only reasonable way to access the evap and heater core.

Coil cleaner or simple green would do well, coupled with the garden hose.

sleepstar 03-01-2014 12:09 AM

people swear by the toyota kit. if you have a toyota dealer nearby they should have it. its a two part kit, a foam cleaner/spray and then a spray mold reducer/eliminator. i'm sure there are equivalent products sold elsewhere.

whunter 03-01-2014 02:55 AM

A suggestion
 
Scrubbing bubbles for evaporator core cleaning.
http://www.scrubbingbubbles.com/Pages/default.aspx?sid=SEM_G_328.kw9364

Be sure to remove the carpets.

.

PackerEdgerton 03-01-2014 11:11 AM

Quote:

Originally Posted by whunter (Post 3294474)
Scrubbing bubbles for evaporator core cleaning.
Scrubbing Bubbles® | SC Johnson

Be sure to remove the carpets.

.

How on earth would you get that stuff up into evaporator core? I'm confused.

Thanks,

Packman.

cooljjay 03-01-2014 02:01 PM

Tear it all apart, it will give you the chance to replace any bad pods and all the foam that lines the flaps in the heater box.....this way you will have it working as it was attended....I am currently doing this to my euro...

whunter 03-02-2014 12:21 AM

Answer
 
Quote:

Originally Posted by whunter (Post 3294474)
Scrubbing bubbles for evaporator core cleaning.
Scrubbing Bubbles® | SC Johnson

Be sure to remove the carpets.

.

Quote:

Originally Posted by PackerEdgerton (Post 3294543)
How on earth would you get that stuff up into evaporator core? I'm confused.

Thanks,

Packman.

I plug the drains and flood the climate control box with Scrubbing Bubbles® | SC Johnson
A vacuum pump is handy for moving the air blend doors, to assure total flooding.

Remove the plugs, allow to drool / drip for an hour, plug the drains, flood the box with water, drain, repeat as needed.


.

PackerEdgerton 03-02-2014 03:31 PM

Quote:

Originally Posted by whunter (Post 3294831)
I plug the drains and flood the climate control box with Scrubbing Bubbles® | SC Johnson
A vacuum pump is handy for moving the air blend doors, to assure total flooding.

Remove the plugs, allow to drool / drip for an hour, plug the drains, flood the box with water, drain, repeat as needed.


.

OK! This is exactly the kind of thing I was hoping for, but I'm still a bit unclear on the exact process, e.g.

1) Where are the plugs?
2) How do you flood the climate control box? i.e. where and how do you spray the scrubbing bubbles?
3) How do you use the vacuum tool to manipulate the blend doors?
4) How do you flood the climate control box with water?

Sorry to be such a noob... is there a pictorial?

Thanks,

Packman

BenzTurbo 03-02-2014 08:48 PM

2 Attachment(s)
i cleaned my evap in my w123 and my dad's old w123 with foaming coil clean from home depot. i dropped the blower and was able to completely clean it. i used my garden hose sprayer on different patterns to get all the crap out and kept my shop vac running to prevent the water from over flowing if the condensation drain were to clog. did the same on my w126. i would not keep the garden hose spraying for long periods as the water can't drain as quickly. also make sure your condensation drain isn't rotten as you will flood your car. if you stick a crevice attachment on your shop vac, you can get all the leaves, ect from the back corner but be very careful because you can easily damage the fins. as for the heater core, i wouldn't worry because the evaporator has probably filtered everything :) i stuck my phone in there to take pics and see if i missed any spots too! these pics were from the w126...

PackerEdgerton 03-03-2014 01:27 PM

Quote:

Originally Posted by BenzTurbo (Post 3295129)
i cleaned my evap in my w123 and my dad's old w123 with foaming coil clean from home depot. i dropped the blower and was able to completely clean it. i used my garden hose sprayer on different patterns to get all the crap out and kept my shop vac running to prevent the water from over flowing if the condensation drain were to clog. did the same on my w126. i would not keep the garden hose spraying for long periods as the water can't drain as quickly. also make sure your condensation drain isn't rotten as you will flood your car. if you stick a crevice attachment on your shop vac, you can get all the leaves, ect from the back corner but be very careful because you can easily damage the fins. as for the heater core, i wouldn't worry because the evaporator has probably filtered everything :) i stuck my phone in there to take pics and see if i missed any spots too! these pics were from the w126...

Thank you, this is quite helpful. I'll give it a try.

Thanks much,

Packman

BenzTurbo 03-03-2014 03:40 PM

Glad I could help! :)


All times are GMT -4. The time now is 03:20 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website