|
|
|
|
|
#1
06-03-2014, 11:08 PM
|
||||
|
||||
|
Rear Bumper Guard?
Hi,
Since I'm getting my car repaired, I'd like to get a Back Bumper Side Guard Panel...I've looked under Bumper Guard, and A lot of Plastic parts come up. This is black rubber, and I want to be sure I've got the right name for it. I have an 83 300D. The parts I did see related to this were quite pricy, I'm hoping for a good price at a salvage place..if i can find it. So can anyone tell me the Correct name for this part? Thanks much (picture attached, I hope) Linda 
|
|
#2
06-04-2014, 02:10 AM
|
|||
|
|||
|
That was a DOT inspired bumper, and the ends (or returns were rubber)
|
|
#3
06-04-2014, 02:11 AM
|
||||
|
||||
|
I think the correct name is bumper joint cover.
__________________
'81 MB 300SD, '82 MB 300D Turbo (sold/RIP), '04 Lincoln Town Car Ultimate Sooner or later every car falls apart, ours does it later! -German Narrator in a MB Promotion Film about the then brand new W123.
|
|
#4
06-04-2014, 02:47 AM
|
|||
|
|||
|
Take a look at www.picknpull.com for 280E, 240D, 230E, 300D. basically any W123 will fit. This would be for a U.S. spec car not the Euro version.
Bumpers are different. Charlie
__________________
there were three HP ratings on the OM616... 1) Not much power 2) Even less power 3) Not nearly enough power!! 240D w/auto Anyone that thinks a 240D is slow drives too fast. 80 240D Naturally Exasperated, 4-Spd 388k DD 150mph spedo 3:58 Diff We are advised to NOT judge ALL Muslims by the actions of a few lunatics, but we are encouraged to judge ALL gun owners by the actions of a few lunatics. Funny how that works
|
 |
| Bookmarks |
|
|
Linear Mode
