|
|
|
#1
|
|||
|
|||
1982 W126 Wipers Quit-Motor Running
Hello,
Today this happened. Looks like I have to start looking for some bad linkages near motor, near false fire wall area. Haven't messed in that areas yet. \ Bummer and no new spares parts I read, or cough up $600. Darn. I can not open Hunters link at end of this below link. It is at the dead end. It is a word doc. Can somebody open it and post as is or as a PDF here somehow? Wipers stopped in a sleet storm! Help! I read a few other links so far, it looks like a PIA job. Any tips are good used parts appreciated! I hear motor running OK both speeds but blades dead in any position I put them. Thanks!, Steve
__________________
1982 300SD |
#2
|
|||
|
|||
Here is some info from the FSM: http://www.startekinfo.com/StarTek/outside/12253/program/Chassis/82-0680.pdf
Maybe it will help to sort out what is going on.
__________________
Sam 84 300SD 350K+ miles ( Blue Belle ) |
#3
|
|||
|
|||
SDBlue,
Thanks for that link! Steve
__________________
1982 300SD |
#4
|
|||
|
|||
Do the blades move by hand per your quote above? Do they move together or independent of each other? If independent, then the splines on the wiper shafts probably have been destroyed. Typically, the splines on the shaft are stronger than the splines on the wiper arm. That allows for replacing the wiper arm instead of pulling the whole linkage and motor.
__________________
Mark in MA 05 MB E320CDI 402k Granite Grey Metallic 05 MB E320CDI 267k Black 05 MB E320CDI 232k White 05 MB E320CDI 209k Tectite Grey 99 Dodge 2500 Cummins 5sp 148k 62 Jeep CJ-6 120k |
#5
|
|||
|
|||
Morning,
Local yard had a 1987 320SEL. I looked up part #'s and a good swap. Fellow tested it and pulled it out and sold whole unit to me for $65. I thought a good price. I found the Ball Joint on mine closest to motor had fallen off. It would go back on but would fall off easily. I put some ATF under the Ball Joint seals since I read that on another link. Maybe 10 drops per joint on the one I put in. New ball joint was very tight on the junk yard unit. Nice way they put all this stuff in there and pretty easy to work on. Hardest part was making sure all the square tangs got put under the windshield when putting back together. Thanks for help guys.
__________________
1982 300SD |
Bookmarks |
|
|