|
|
|
|
|
#1
05-19-2002, 08:14 PM
|
|||
|
|||
|
RVT sealant for water pump replacement?
Hi
When replacing water pump, should I use RTV sealant in between the gasket? If so, what type RVT is good ? Is Permantex's "Ultra Gold" suitable for this application? Thank you Steve 
|
|
#2
05-19-2002, 08:44 PM
|
|||
|
|||
|
Yes, use the high temperature permatex stuff, it is orange. Only a thin layer, don't make it so thick it oozes out the sides.
|
|
#3
05-20-2002, 03:51 AM
|
|||
|
|||
|
Here is what I do with RTV sealants... I really clean the surfaces to be mated... then I put as thin a coat on each surface to be mated as I can... including both sides of the gasket... and let them cure.. like 12 hours... then when I am ready to put the item on I place another thin layer on all surfaces and quickly put them together... I use my finger to get it thin... and I just pull it down tight enough to be sure it is evenly contacted ... then I let that cure and then put the proper torque on the bolts... I have not had this method leak in 20 years... yes it is compulsive/obsessive...but when you have to take a bunch of stuff off just once you may decide the peace of mind is worth it...... if you study the reasons for RTV gasket failures you will recognize this as a method of avoiding them...
 Greg
|
 |
| Bookmarks |
|
|
Linear Mode
