|
|
|
#1
|
|||
|
|||
trans for 190D fit 300D?
hello,
I need a transmission for my 87 300D turbo I found an 87 190D non turbo Will the trans for the 190D fit in my 300D? |
#2
|
|||
|
|||
Your 300D has a 722.3, the 190d had a 722.4. The transmission will fit but it won't last very long with the 603t torque. Also the driveshaft yoke is different.
__________________
CENSORED due to not family friendly words |
#3
|
|||
|
|||
Thanks you. That is what I needed to know.
|
#4
|
||||
|
||||
I have a good tranny from my 95 with 606 non turbo. I am not sure if its what you need or not.
__________________
[SIGPIC] Diesel loving autocrossing grandpa Architect. 08 Dodge 3/4 ton with Cummins & six speed; I have had about 35 benzes. I have a 39 Studebaker Coupe Express pickup in which I have had installed a 617 turbo and a five speed manual.[SIGPIC] ..I also have a 427 Cobra replica with an aluminum chassis. |
#5
|
|||
|
|||
I'm pretty sure the 95 is also a 722.4.
__________________
CENSORED due to not family friendly words |
#6
|
||||
|
||||
__________________
[SIGPIC] Diesel loving autocrossing grandpa Architect. 08 Dodge 3/4 ton with Cummins & six speed; I have had about 35 benzes. I have a 39 Studebaker Coupe Express pickup in which I have had installed a 617 turbo and a five speed manual.[SIGPIC] ..I also have a 427 Cobra replica with an aluminum chassis. |
#7
|
|||
|
|||
Yes. There is an engine torque limit around ~170ish where everything below that number got 722.4 and everything above if got the 722.3. The 260e, e300d and all the 4cyl gasser w124s sold in Europe got the 722.4. These also had smaller flex disk and thinner spline at the center support bearing. The 722.3 is physically larger and makes fitting it in the w201 chassis difficult. That's why the factory never sold a 3.0 m103/w201.
__________________
CENSORED due to not family friendly words |
Bookmarks |
|
|