|
|
|
|
|
#1
02-13-2018, 05:35 PM
|
|||
|
|||
|
240D starter solenoid fiasco
Hi,
After having a few too many hands in the job, the starter isn't working properly. I didn't see the "helpers" remove the starter wires, or assemble the solenoid. The new solenoid arrived without instructions, and there was some "silicone" rubber seal on it that would fit inside when assembled. I think that seal is messing things up. Any help out there? snapped_bolt
__________________
'81 240D For now, a good place to borrow new parts '80 300TD Probably will be put back into service! '79 240D BACK IN SERVICE SINCE 09/16; limited use, oil leak. Guide pin r/sealed/replaced. Still a leak. Front crank seal.... 
|
 |
| Bookmarks |
|
|
Linear Mode
