|
|
|
#1
|
||||
|
||||
Fuel tank sending unit problems...
Vehicle is an 82' 300sd, took out the sending unit to clean. upon cleaning the init one of the silver wires on the side sperated from the soldered poin on the unit. I had to locate some wire that was the same size and i soldered the unit back together. Once reinstalled my dash display is pegged out at the full tank point. Does anybody have any input on this, i did see something about the wire having the proper resistance? Is it possible i need to source out different wire.?
Thoughts thanks- Nick
__________________
82' 300SD |
#2
|
|||
|
|||
I'd replace the unit but I have a spare if something happens to mine. If you're set on replacing the wire perhaps you can test the resistance though the other. I can't imagine they would be different.
__________________
84 300SD 85 380SE 83 528e 95 318ic |
Bookmarks |
|
|