|
|
|
#1
|
||||
|
||||
61x Temp sensors
Has anyone had good luck or bad with the cheaper temps sensors available? The range is about $7 (Meyle, facet) to about $28 (OE).
__________________
CC: NSA All things are burning, know this and be released. 82 Benz 240 D, Kuan Yin 12 Ford Escape 4wd You're four times It's hard to more likely to concentrate on have an accident two things when you're on at the same time. a cell phone. www.kiva.org It's not like there's anything wrong with feeling good, is there? |
#2
|
|||
|
|||
I hope this isn’t too irrelevant because I haven’t used the Meyle temp sensor, but I’ve had terrible luck with any W123 Meyle part I’ve used. At $28 for an OEM sensor, I’d throw in the change knowing that the original lasted 30+ years. A faulty temperature reading can lead to a lot more damage than a $28 part should lay claim to.
Ironically, I’ve used Meyle without a problem on multiple E46’s, but the W123 line just sucks. |
#3
|
|||
|
|||
With a combined 350,000 or so miles on 617.x engines, I tend to opt for either genuine M-B parts or OE to M-B parts. Now then, a caveat for the latter is that on one occasion, I discovered that the part (front suspension) was made in China. I returned it. True: The detail of manufacturing of the part was clearly not adequate and that is how I got to wondering why it seemed unusual and went back and examined the package it came in and found the country of manufacture.
I would pay heed to the sentiment expressed on this thread by TJ513. Remember: The 617.x engine is a high precision piece of machinery (unlike most of its era and modern brethren) and choosing to use parts on it that are not of adequate quality is a means for significantly increasing the opportunities for failure. |
Bookmarks |
|
|