|
|
|
#1
|
|||
|
|||
How to test MAP/MAF sensor
The WIS I have is not showing how to test the MAP and MAF sensors. This is a pretty critical piece of data to work on vehicles. Does someone know how to do this and/or what the resistance should be between the pins? I searched for Bosch too and came up empty.
__________________
2005 E320 CDI - 101K |
#2
|
|||
|
|||
for map just hook up a pressure/vacuum gauge and compare with ecu value
|
#3
|
|||
|
|||
Accordingly to the diagnostics, the Boost pressure, Atmospheric pressure and Intake Air pressure should all be within 30 hPa. I measured mine, they are below
boost- 976 atmospheric -990 intake air- 790 I bought a new map pressure sensor and the same readings were thrown for both. I am thinking of replacing the MAF. I am throwing a e2025 B28/5 which is the signal voltage too high. I have noticed my MPG is significantly lower at 26-27 highway and it has a sluggishness. It's possible the new Bosch sensor I purchased is bad, but I doubt that is the case. Is there any other sensor that would cause the intake to be lower? Can someone read their's and report back?
__________________
2005 E320 CDI - 101K |
Bookmarks |
|
|