W123 R4 Bolts and Spacers
 

Tried to search this one to avoid multiples, but just couldn't find an answer.

LOOOONG story short, my 85 W123 300D needs a new compressor. I went with just replacing the frozen up R4 that was there. However, thangs happen and I need new bolts and spacers. I found a size for replacement bolts, but I can't find any info on the spacers.

If anyone could tell me, I'd greatly appreciate it!

Bobby
Tulsa, OK

Oh boy.

I’ve been there. There are two approx one cm thick spacers and a bracket spacer (not exactly sure what to call it) that’s a few inches (photos are abundant). For grip, there’s also a wave washer on the cap end of each bolt I lost one of the smaller spacers and after utter failure to procure said info, found the bits at a local JY.

That wasn’t much help… good luck.

Thanks, Shern. Hopefully the right person will see this post!

I suppose I could pull a set, and measure them for ya…