w123 steering damper replacement
Hi,
After reading Nic's post about redoing suspension parts, I am considering doing the steering damper. I am a pretty tall, big guy, so messing around under the car is kind of tough for me, my arms tend to be too long, etc., but anyway, I like to do as much stuff as I can. Things like all the tie rods I think are best left to someone who has a lift, its kind of hard for me with my jackstands. Overall the suspension in my car seems pretty good, but the steering is a bit lacking. I figure if I change the steering damper, and lube everything up, it may help somewhat. Could someone outline the procedure to replace the steering damper on a 123, including torque values if possible? Also, are there any other parts that would be reccomended to be replaced because either they have to come off when the steering damper comes off, or because they will cause the new damper to go bad really quick? Also, could someone give me an outline of what all I should lube on my 300D? I have never tried it on this car, but I assume there are just a bunch of zerk fittings. Does anyone know how many there are? Would it be possible to get a list of how many and their approximate locations? I would like to do a full front and rear (if it is possible on these cars) lube job. Thanks in advance for the help, JMH |
JMH,
I replaced the dampner on my car recently. I'm pretty tall also and didn't have any problems getting under and having access to the 2 bolts that hold the thing in place. Crawl under there and look at it. It's a 5-10 minute job at most....barring any siezed bolts, etc. piece of cake. Just wish replacing other items were as easy! I couldn't find any torque values listed for it...then again, once you see it, you'll see that it's prolly a 1 'Ugh' type bolt ;) |
some ideas
Also, could someone give me an outline of what all I should lube on my 300D?
- the engine - the wheel bearings after a repack - the differential - the throttle linkage ball joints there is no need to lube any of the suspension components from anything I have read or heard (which is getting to be a lot at this point) As far as increasing access, a real easy way to get an extra 1.5 inches is to drive the front wheels onto a pair of 2X6 planks. That extra space can help and there is no potential for falling off. For simple jobs, this is what I usually do. It is a whole other question whether this will really help your situation with the steering or not. Replacing the damper is not known for dramatically improving steering- especially if there are any tie rods or center rod that have ripped boots and associated play. Likewise, upper/lower ball joints, idler arm and steering box adjustment are more likely to yield results. (this is based on replacement of 3 dampers in 3 123/126s). Best of luck. |
All times are GMT -4. The time now is 02:54 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website