|
|
|
#1
|
||||
|
||||
Acceleration Pull
While under hard acceleration I get a slight pull to the left... let go of the throttle..... Slight pull to the right.
My guess it's the front / rear alignment, but suppose it could be some other suspension issue. Any suggestions? Thanks in advance. Don
__________________
1980 300TD-T (82 Turbo and Trans) 159,000 Miles "Jackie-O" 1983 300SD 272,000 Miles "Aristotle" 1987 Jeep Wagoneer Limited - keeps the MB's off the ice and out of the snow 1994 BMW 530it |
#2
|
||||
|
||||
You have a bad front end component. I would say check the idler arm first. Then check out the entire front end: ball joints, control arm bushings, tie rod ends etc. You will find one of them is pretty bad causing the drifting on acceleration.
__________________
Orland Park, IL 1985 300SD 215,000 miles |
#3
|
||||
|
||||
Thanks for the input.
In the last 2 weeks I have changed the idler arm bushings, right and left tie-rods and the drag link. The upper control arms look new, so I guess it is the lower ball joints, lower control arm bushings, guide rod / bushings or my steering gearbox (which makes a clack-click sound with small and rapid right to left movement of the steering wheel) all of which need replacement. Don
__________________
1980 300TD-T (82 Turbo and Trans) 159,000 Miles "Jackie-O" 1983 300SD 272,000 Miles "Aristotle" 1987 Jeep Wagoneer Limited - keeps the MB's off the ice and out of the snow 1994 BMW 530it |
#4
|
||||
|
||||
For what its worth....I was thinkin final drive, where gears need to be shimmed at differntial - or one axle might be played.
__________________
'80 300SD/ w116 '79 240D 4-spd '71 750cc Guzzi previously owned: '83 240D 4-spd '77 280SEL 4-spd '74 280/8 '72 250/8 '65 220Sb 4-spd '63 220Sb 4-spd '63 190c 4-spd '61 220Sb 4-spd '60 190b 4-spd |
Bookmarks |
|
|