Need P/N For ........

[TomJ]

Tried to order a new timing chain link and thought I'd order a few other gaskets and small parts while I'm at it.

None of the order houses have a listing for the hose that goes from the water pump to the thermo housing (about 2" diameter and about 3" long).

Also need a P/N for the grommet on top of the air cleaner that seals the bypass/engine vent hose.

And the two O-rings on the extension that goes from the turbo to the intake manifold, (two large orings.)

Anyone have P/N's for these??

Thanks for any help!!

[BoostnBenz]

The parts places all carry that hose but won't cut it to length (~$55). I ended up going to my stealership for it. I'm sure if you call Phil (fastlane, link at top) or Rusty (***************) they'll not only get the part number they can order it for you.

[sixto]

I can look it up in the EPC if I know what car it's for.

Sixto
95 S420
87 300SDL
83 300SD ... $950, see cars forum

[BoostnBenz]

Where do you get that EPC? My stealership is about 50/50 on getting the right part. His profile says 84 300D, probably a good idea to put it in your sig instead.

[sixto]

Originally posted by BoostnBenz
His profile says 84 300D, probably a good idea to put it in your sig instead.

But I never tire of that joke

Talk to speedy300turbo (?). He can point you in the direction of an EPC set.

The 40mm stub hose is 900271 042012. Strange part number. Maybe it's offered in bulk.

The turbo-to-manifold o-rings are 004 997 54 48.

I don't see a valid grommet in the valve cover, just fittings and hoses. There's a variety of hoses and I don't know which one a Feredeal 84 has.

Sixto
95 S420
87 300SDL
83 300SD ... $950, see cars forum

[TomJ]

Originally posted by sixto
.....
The 40mm stub hose is 900271 042012. Strange part number. Maybe it's offered in bulk.

Thanks a million for the #'s. For the hose, it's looking like it comes in 1meter lengths. So....., maybe I should buy one, cut it up into the stub hoses and offer to others here at cost? Otherwise, I'll find an old Jeep radiator hose and use that, not buying $55/1meter worth of hose to
cut 3" off and throw the rest away.

Originally posted by sixto
.....
I don't see a valid grommet in the valve cover, just fittings and hoses......

Oh well, maybe will have to make that too. The one I have is hard and leaks unfiltered air into the intake.

Thanks again for all the info!!