Coolant hose diameter in 84 300d?
Well, I measured as best as I could and it was wrong...so the car sits in the garage until I get the right one.
The hose in question is the 4" long hose that is underneath the thermostat housing. Anyone know the diameter? I know for sure it is not 2". Thanks in advance! |
Don't quote me on this but I believe it is XXmm, of course it isn't english units. :) To bad no online parts store can get it in a short length, I got mine from satan for $7. Why not just get the MB part, it always makes me feel better knowing it is the right part instead of something that could work.
|
42mm ID (called a "stub hose"). Just go to a Napa or Carquest and get their by-the-inch hi-pressure hose. It's actually a few steps up from the stock MB quality (has a braided outer casing). I'll go into town tomorrow and get them to cut 1/2 dozen or so of them. Email me.
|
just a suggestion, before you go replacing the hose. if it's not clearly leaking from the sides but just from the bottom or top, you could try putting on 2 new hose clamps. it worked for me! also it is a lot less work to do that than to replace the entire hose.
|
Thanks all,
My hose definately needed to be replaced, glad I found out about it after the long road trip! TomJ, I'm going to the big city (Anchorage) today so I'll make a NAPA stop while I'm there. If I have any problems I'll drop you an email. Thanks for the advice. Chuck |
All times are GMT -4. The time now is 03:08 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website