|
|
|
#1
|
|||
|
|||
Wood Trim For Glovebox w123
Well yesterday, as I was putting stuff in the front seat. I accidently cracked the wood trim for the glovebox.(the wood trim was hanging off a little bit) I was going to glue it back today actually but now I don't think I can. Does anyone know where I could get the wood trim for the glovebox on my 1980 240D or have one I could buy. But, it'd have to be in mint condition.
__________________
2002 S500 2000 C230 Sport Kompressor 1996 S600 1980 240D Diesel 1977 300D Diesel |
#2
|
||||
|
||||
First place you should look is ebay. Most of the time they are part of a set but even then you'll often pay less for all of the pieces then you would if you only bought the one piece from a wrecking yard.
Good luck!
__________________
DJ 84 300D Turbodiesel 190K with 4 speed manual sold in 03/2012 |
#3
|
|||
|
|||
Thank I will look. If by any chance anyone does find one please e-mail me ASAP. Thanks!
__________________
2002 S500 2000 C230 Sport Kompressor 1996 S600 1980 240D Diesel 1977 300D Diesel |
#4
|
|||
|
|||
I do believe I have that piece out in my garage from my old car. Make me an offer and it is yours.
Mike
__________________
Mike '80 300D '84 300D '85 300D '87 300D |
#5
|
||||
|
||||
What glue would you use to attach it?
__________________
Mark Herzig 1995 E300D 153K 1985 300D 142K (sold) 1979 450SL 122 miles (sold) 1992 500E 127K (sold) 1987 300SDL 132K (sold) 1986 300E 161K (sold) |
#6
|
||||
|
||||
I used Anchor-tite epoxy for my trim. Comes in a two-part syringe type system. Worked great. They'll never fall off again.
__________________
DJ 84 300D Turbodiesel 190K with 4 speed manual sold in 03/2012 |
#7
|
|||
|
|||
Glove box door trim
That one is a pita to get off. I tried to pull one off a donor and broke the glove box locking mechanism trying to squeeze the slider tabs together enough to remove the slider and then get the wood trim off. I finaly gave up as I didn't want to destroy my working glove box lock.
Anyone got any tricks to pulling that slider on the latch mechanism? I still have a good piece of wood that I reglued to the metal backing but don't want to buy a new blue glove box door after I destroy my lock...
__________________
'99 S420 - Mommies '72 280SE 4.5 - looking to breathe life into it '84 300SD Grey - Sold '85 300SD Silver - Sold '78 Ski Nautique |
#8
|
||||
|
||||
I've glued that on before with just some weatherstrip adhesive, or on the other pieces I've taken the factory metal portion out and use 3M's acyrlic double sided panel tape. As long as the surfaces are clean I don't think that stuff ever lets go, unless you put a heat gun on it.
__________________
Jeff M. Mercedes W123 DIY pages are now located here. 1983 / 1984 300D Sold 2000 CLK430 Cabriolet ~58k Sold 2005 Avalanche 4x4 ~66k |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|