|
|
|
#1
|
|||
|
|||
valves from turbo engine into non turbo engine
Are they the same size? intake and exhaust valves from a turbo 617 and a non turbo 616. If they are not the same size , what was needed to fit them? Or is this not doable?
__________________
1977 240D turbo |
#2
|
||||
|
||||
616s and 617s appear to be "modular" parts routinly swap back and forth. Worst case you might have to have a machine shop open up the seats a little. if my 616 survived that was on the list I will try and get some sizes for you.
__________________
1996 s10 zr2 with a 6.5 turbo diesel 1996 c2500 suburban with a 6.5 turbo diesel 1981 300sd with a turbo 617 Monte carlo figure 8 car |
#3
|
||||
|
||||
83 616
Sorry got the info in two different forms, if you dig through im sure you will find what you need Edit: I quit being lazy, they look the same to me.
__________________
1996 s10 zr2 with a 6.5 turbo diesel 1996 c2500 suburban with a 6.5 turbo diesel 1981 300sd with a turbo 617 Monte carlo figure 8 car |
#4
|
|||
|
|||
thanks, they do look like they should be able to be used in either. The longer stem I think is the uprated engines.
I am building a new engine as a future replacement for mine. it will still be a 616, but want to set it up so I can turbo it later. My current engine is doing ok but has a lot of miles on it, and is a bit tired. So I know sooner or later will need to do something.
__________________
1977 240D turbo |
#5
|
|||
|
|||
Just for those who may wonder this too, I have put the 617 exhaust valves in the 616. Needed to regrind the valve face to match the head. otherwise a perfect fit.
__________________
1977 240D turbo |
#6
|
||||
|
||||
badass
__________________
1996 s10 zr2 with a 6.5 turbo diesel 1996 c2500 suburban with a 6.5 turbo diesel 1981 300sd with a turbo 617 Monte carlo figure 8 car |
Bookmarks |
|
|