Diagram for aiming wiper washer jets
 

Does any knowledgeable Benz enthusiast have a diagram for aiming the wiper jets on my '93 300CE?

here is the diagram from service literature

the adjuster tool is mb # 110-589-02-63-00

Cool. Thanks. I use i sewing needle or Pin. Works like a champ. Never thought about crossing the streams. I thought crossing the streams was BAD!!!
Dr. Egon Spengler: There's something very important I forgot to tell you.Dr. Peter Venkman: What?Dr. Egon Spengler: Don't cross the streams.Dr. Peter Venkman: Why?Dr. Egon Spengler: It would be bad.Dr. Peter Venkman: I'm a little fuzzy on the whole "good/bad" thing here. What do you mean, "bad"?
Dr. Egon Spengler: Try to imagine all life as you know it stopping instantaneously and every molecule in your body exploding at the speed of light.Dr. Ray Stantz: Total protonic reversal!Dr. Peter Venkman: That's bad. Okay. All right, important safety tip. Thanks, Egon.hmmm.. just like in the movie crossing the stream is Good...

aiming streams
 

Hey guys, new to the forum and the whole MB cult... I have an '84 300SD with the wiper nozzles that work, but just don't spray where I need them too. So my question is, how do you use a needle to aim them? I'm guessing just stick it in the outlet hole and adjust away, but want to make sure I don't ruin them... is this correct?

I set one on each side to the window and one set to spray over the car and onto the car behind that is following to close. They get the message and back off.

God

I dident even know they had that. When I did QA at MB they would have shot me if I insisted on aiming to that close a spec. Might you have one for a 560SL.

John Roncallo

I almost spit out my drink :D

That's funny, right there!