|
|
|
#1
|
|||
|
|||
Need 300 logo measurements
I am replacing the 300SL type designator on the rear deck of my car. I would appreciate someone with a factory original deck and logo measuring the exact distance from the left edge of the deck lid to the left end of the underline, and from the bottom edge of the deck lid to the bottom of the underline.
Thanks in advance for your advice. Bob D. Last edited by Robert Deming; 08-21-2006 at 05:37 PM. Reason: message was incomplete |
#2
|
|||
|
|||
From WIS ...
__________________
Kent Christensen Albuquerque '07 GL320CDI, '10 CL550. '01 Porsche Boxster Two BMW motorcycles |
#3
|
||||
|
||||
Hmmm...you learn something new every day. Didn't think about heating it and the mating surface, although I have enough sense not to try this in 30 degree weather...just leaving the car out along with the part on a sunny june/july afternoon should also work....
__________________
86 560SL With homebrew first gear start! 85 380SL Daily Driver Project http://juliepalooza.8m.com/sl/mercedes.htm |
#4
|
|||
|
|||
Thanks for advice
Thank you both very much. The positioning information from the WIS is exactly what I needed, and I also value the comment about warming the car in the sun.
Bob D. |
Bookmarks |
|
|