Need to Find replacemetn MICROSWITCH for ACC on 72 450
1 Attachment(s)
I am into repair of all the vacuum and heater controls and found that the source of one of my issues is that the microswitch that sits under the heater arm ( 1st version ACC) are both messed up and are not sending the open close signal to the dashpots. Where in the world can I find these, no part number, and only referred to as microswitch in the repair manual.
|
Are you sure they are bad? Have you checked them out of circuit for short/open action.
Maybe the grease inside has gotten hard after 30+ years. I would try get a little WD40 inside and push the pin a few times to try to free it up if you do not get the short/open action. These are definitly not your standard microswitch so they will be hard to find. Have you called Phil to see if he can locate them? I had to fix a Jag AC controler microswitch problem before but I was able to find after market ones that had the same size and action (normally open). If you can figure out the action you could make a mounting plate to fit a new switch to make it work. |
I got one to work the other will not work. I have found a similar switch at radio shack and I am attempting to make a braket that will work. Thanks for the response!
|
I purchased two small switches from Radio shack and made some aluminum brackets. Put them in place of the other ones, reconnected all the lines and I now have a fully functional heater valve that I can open and close from the cockpit, jsut as designed:sultan:
|
Only one needs to work, if you know which one it is, just move that temp lever to get heat.
230/8 |
yup, figured that out when I got them both in
|
All times are GMT -4. The time now is 11:36 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website