|
|
|
#1
|
|||
|
|||
shifter linkage
Hi All,
I had to replace the plastic bushings on the sifter linkage rod on my '83 380SL. I have not paid too much attention and do not remember which orientation the rod was in. Is the rod on the left side or the right side of the shifter stick connector?
__________________
1983 560SL Megasquirted (originally 380SL) My former Mercedes: 1985 300SD ~190k 1990 560SEL 2000 C220 CDI 1983 380SEC 102k dual-chain conversion 2000 C280 70k (sold) 1987 300DT (W124 - sold) 1972 220D (sold) 1971 220D (sold) |
#2
|
|||
|
|||
Left, fore and aft.
|
#3
|
|||
|
|||
So the linkage rod is further away (instead of closer) from the drive shaft, right?
__________________
1983 560SL Megasquirted (originally 380SL) My former Mercedes: 1985 300SD ~190k 1990 560SEL 2000 C220 CDI 1983 380SEC 102k dual-chain conversion 2000 C280 70k (sold) 1987 300DT (W124 - sold) 1972 220D (sold) 1971 220D (sold) |
#4
|
|||
|
|||
Yes, and closer to the driver's side of the car. You always see a picture of these things on the EPC or the Russian site - http://www.detali.ru/cat/oem_mb0.asp?TP=1 then 380SL, then 26, then 60.
|
Bookmarks |
|
|