|
|
|
#1
|
|||
|
|||
79 450SL Blower
on my 79 450SL blower only works when I turn on A/C
anyone know fit? Jim
__________________
Jim |
#2
|
||||
|
||||
Don't know fit, but I would check for vacuum leaks under dash or possible even a switch-over valve failure.
__________________
Question Authority before it Questions you. |
#3
|
|||
|
|||
The blower circuit is turned on in the heating mode by a vacuum switch. The condition of blower in AC only usually means you have a large enough vacuum leak, or leaks, that the vacuum switch can't operate to engage the blower motor. I suggest that you get a mighty vac, or the Harbor Freight equivalent, and start checking your vacuum pods and lines for the leak. I went through this with my '79 a few years ago, and ended up installing the digital upgrade advertised in this forum, as I found not only bad pods, but the mechanical nightmare that is the heater servo was totally shot. I am extremely happy with the digital upgrade! Spendy, but it works very well.
__________________
Richard Wooldridge '01 ML320 '82 300D 4.3L V6/T700R4 conversion '82 380SL, '86 560SL engine/trans. installed '79 450SL, digital servo update '75 280C |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|