|
|
|
|
|
#1
02-07-2012, 11:20 PM
|
||||
|
||||
|
Need a broken ECU
I am building a breakout box to test and tune my D-Jet system. I have two salvaged engine harnesses, project box, bananna jacks, and design complete. I need the ECU card edge that the AMP 925079 harness connector mates with. I do not want to trash an operable ECU and am looking at an eBay candidate. I just wonder if one of you has a broken ECU collecting dust that you are willing to sell me.
I will share the project plans on this foruml when I finish (if it works).
__________________
Brad Cushman '73 450 SL 
|
|
#3
02-16-2012, 03:42 PM
|
||||
|
||||
|
Id love to see the finished product.
If you have any junk yards around they would be a good place to source them too.
__________________
1985 300D 198K sold 1982 300D 202K 1989 300E 125K 1992 940T "If you dont have time to do it safely, you dont have time to do it" "The democracy will cease to exist when you take away from those who are willing to work and give to those who would not."
|
|
#4
02-18-2012, 04:06 AM
|
||||
|
||||
|
TnBob
I just bought an ECU from a Saab 99 on eBay. I will harvest the card edge and solder up the breakout box. Then I'll test the box on a spare ECU, pressure sensor, throttle valve, air temp and water temp sensors. If all that works, I'll run the tests on my car. I'll post results, lessons learned and pictures.
__________________
Brad Cushman '73 450 SL
|
 |
| Bookmarks |
|
|
Linear Mode
