|
|
|
#1
|
|||
|
|||
Heater now needed
As the cold weather is gaining a foot hold here in St. Louis, I need the heated in my 1986 SL. The blower and the auto temp control works, however, it only blows out from the two outside dash vents. Does not blow thru the middle dash or the floor vents.
Thanks in advance for and ideas on keeping warm this winder. Mick 1986 SL 1986 300E 1989 Bronco ll |
#2
|
|||
|
|||
sl heater
I had trouble with my '77 450slc heater blowing hot air (more of which I don't need in S. Texas) down the driver's side door and around my feet. The mechanic (factury trained who works for the local dealer but on the side in the evenings at half the hourly rate) said the problem is that one of the vacuum pot that controls the hot water flow is bad. Not only does it cause the water control valve not to close but the leaking vacuum causes the engine to run a bit rough and deprives vacuum from other pots in the system. The pot is only about $20 and a bit of labor. I am sure that the entire heating system is crawling with these pots-anyone of which could be leaking.
|
Bookmarks |
|
|