|
|
|
#16
|
||||
|
||||
Quote:
__________________
D. Chang Network Integration Engineer MCSE, CLP, CCNA |
#17
|
|||
|
|||
I copied the following off another post:
On the back dash thing, the only way I know to get that little space cleaned out is to actually remove the little dash when you have the top off. You have to take out one of the side pieces too, because they hold the middle one down. (It's just the 6 or 8 phillips screws underneath and also the lock-down screw on the side.) I've only done it once, after a particularly untidy bug got down there. |
#18
|
||||
|
||||
installed!
Got it from Caliber Motors, Tom Hanson came through as usual...the request for the part had to go to the Classic Center. Got it last night, put it in today...not very hard at all to do.
Hardest part was getting the mounting point on the left side of the hardtop adjusted to right length so it would engage the lock. Had to remove and put on the hardtop three times before I got it right, luckily I had an electric winch. thanks maheath for the part number! dchang
__________________
D. Chang Network Integration Engineer MCSE, CLP, CCNA |
Bookmarks |
|
|