|
|
|
#1
|
||||
|
||||
WTB: Cold Start Valve M130 Injected
I desperately need a used cold start valve for an injected M130 (280SE, but one from any injected 250/280 etc should work).
In particular I need the part that the wire hooks to, held in by two screws, right next to the pass side shock bolt. Thanks!! -Matt-
__________________
Currently: 1972 350SL Euro 4spd 1973 BMW R75/5 1981 BMW R80GS 1995 FZJ80 with OM606 Conversion In Progress |
#2
|
|||
|
|||
do you still need it there is a 280
There is a fresh 280se at a pick your part by me three days ago it was pretty complete except the injectors and one door was gone I am not familiar with this part so I would need a part # they are very reasonable on most there prices if this is a under a pound control valve it would cost you about $16 plus shipping unless it is very difficult to remove and I only take parts off cars that have been well cared for but wrecked or blown transmissions rod through blocks ECT no parts from cars that have sat for the last 10 years bald tires trashed interiors ECT I test parts when possible before I buy them and am capable of testing many electrical and electromechanical parts at the yard before I buy them.
Dave S San Jose CA Mattdave@pacbell.net |
Bookmarks |
|
|