|
|
|
|
|
#1
08-06-2001, 07:04 PM
|
|||
|
|||
|
72- 250 -parting out
I have a 71 250 that runs but the engine needs work..(rings, head gasket...)
I will be taking the trans out of it to put in a 72 250, but the rest will be ripe for the pickings! Body is good - interior is fair. Take the whole thing (with the trans from the 72, for $500 or trade for? (mig welder perhaps?) 
|
|
#2
08-18-2001, 10:53 AM
|
|||
|
|||
|
Hi,
I could use a cylinder head with cam and towers for my 71 250C. I also need the seat stops that keep the seat from folding all the way back. Just the small fitting in the rear side of the seat bottom. Any hope for these parts? Where are you located?
|
|
#3
08-19-2001, 10:26 AM
|
||||
|
||||
|
Can you snap a picture of the carbs? I am look for a few varients to the zeniths for a website. I'm interested in seeing the fittings where fuel comes and goes from the front carb.
-CTH
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| parting out 1972 250 c | busfarmer | Vintage Mercedes Forum | 0 | 09-04-2002 07:03 PM |
| 250 SE Coupe Manual Gearbox | Fredman63 | Vintage Mercedes Forum | 1 | 07-23-2002 11:26 AM |
| Engine temp. problem on 1972 250 | hippie_elmo | Vintage Mercedes Forum | 2 | 06-06-2002 10:12 AM |
| 72 250 trans wont shift into 3rd | Snegs | Vintage Mercedes Forum | 1 | 08-07-2001 08:46 AM |
| 72 250 trans wont shift into 3rd | Snegs | Tech Help | 0 | 08-06-2001 03:26 PM |
Linear Mode
