Hello,
Looking to buy a used 240d automatic transmission crossmember. If you got one let me know. Thank you for your time.

I'm sure I have one. Do you have a picture of one so I can be sure and get the right one?

__________________
[SIGPIC] Diesel loving autocrossing grandpa Architect. 08 Dodge 3/4 ton with Cummins & six speed; I have had about 35 benzes. I have a 39 Studebaker Coupe Express pickup in which I have had installed a 617 turbo and a five speed manual.[SIGPIC]

..I also have a 427 Cobra replica with an aluminum chassis.

I think i may have a photo of it some where? i will find it and post it. thanks

i am also looking to get the shifting rods as well, the ones i have got bent by the guy who removed them.

I try to straighten the rods. Can't be that hard if he bent them by accident can it?

I was looking for something else this morning and found two cross members. I probably have others as well.

When you post the pic please include the distance between the bolt holes side to side.

__________________
[SIGPIC] Diesel loving autocrossing grandpa Architect. 08 Dodge 3/4 ton with Cummins & six speed; I have had about 35 benzes. I have a 39 Studebaker Coupe Express pickup in which I have had installed a 617 turbo and a five speed manual.[SIGPIC]

..I also have a 427 Cobra replica with an aluminum chassis.

Tom - I measured mine between the two rear mounting holes and got 11" on center. That measurement should be a little higher for the front two holes as the trans tunnel tapers in towards the back.

__________________

1981 300TD "The Green Lantern"
1980 300TD
1983 300D Euro "China Cat"

thank you StaggerLee.

do you still need a pic? If you have one let me know....thank you again.

you should see these shift rods! one is bent so bad it looks like a "C"! I do not know what that guy did, but he messed those puppies up good.

Sorry it has taken me so long to post a picture of the cross member, as I am a technological moron! Can any body tell the easy way to do this? Thanks!