|
|
|
|
|
|||||||
 |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
05-08-2013, 08:58 AM
|
|||
|
|||
|
WTB: iron case 4-speed manual or good output shaft/yoke for same
I swapped an iron case 4-speed manual into my 300TD ... noticed that the output yoke on the ebay-sourced tranny was a little wobbly with some significant play. I put the trans in the car anyways to finish the project, and it works fine but I can tell that there is lash in the rear yoke.
So, I'm looking for another good iron-case tranny or an output shaft and yoke (assume both are worn). Thanks in advance! -Dan (Upstate SC) PS- heck, if you happen to have a getrag 5-speed and/or 38# flywheel laying around, that would also fit the bill. 
__________________
1976 w115 300D 4-speed conversion!!  1985 w123 300TD 4-speed conversion!! Non-Mercedes old stuff: 1941 Buick Special (Straight 8!) 1946 Luscombe 8a 1947 Willys CJ2a 1950 Chevrolet 4400 dump truck 1954 Chevrolet 3600 3/4 ton 1954 Cessna 195B 1955 John Deere model 40 1991 Ford Taurus SHO 2013 Jetta SportWagen TDI 6-speed (I sold out...
|
|
#2
05-08-2013, 04:19 PM
|
||||
|
||||
|
I have a very very nice yoke (3 dog ear piece). Not absolute dealer new, but pretty close. I ended up buying one from Peachparts then my car got totaled. $40.00 plus shipping.
|
|
#3
05-09-2013, 10:21 AM
|
|||
|
|||
Quote:
Anyone else, holler if you have a tranny or an output shaft... Thanks!! -Dan
__________________
1976 w115 300D 4-speed conversion!! 1985 w123 300TD 4-speed conversion!! Non-Mercedes old stuff: 1941 Buick Special (Straight 8!) 1946 Luscombe 8a 1947 Willys CJ2a 1950 Chevrolet 4400 dump truck 1954 Chevrolet 3600 3/4 ton 1954 Cessna 195B 1955 John Deere model 40 1991 Ford Taurus SHO 2013 Jetta SportWagen TDI 6-speed (I sold out...
|
|
| Bookmarks |
|
|
Linear Mode
