|
|
|
#1
|
|||
|
|||
WTB: W108 250SE Cooling Pipes
Hello everyone. I am looking to replace some coolant pipes on my 1968 250SE. They are all badly rusted, a couple have some pin holes in them, and one is badly clogged. I am considering attempting to have them repaired, but they may be beyond repair.
My car sat in storage for 11 years with apparently very diluted coolant and as such has a number of rusted items. Waterpump, thermostat, etc are all being replaced, and we finally have clean water coming from the engine after flushing. Anyway, if anyone has any leads for these items I would be most appreciative! Thank you!
__________________
1968 250SE |
#2
|
|||
|
|||
PM sent.
|
#3
|
|||
|
|||
Bump, still looking for either good used parts, or someone who can fabricate new pipes. This is the last thing keeping me from putting the vehicle back together! Thank you!
__________________
1968 250SE |
#4
|
|||
|
|||
I can fabricate the pipes with copper, aluminum or steel. You can tow your car into my shop and I can make the pipes there or mail in the pipes that I can duplicate.
Attached is a stainless steel EGR pipe I made this week for a neighboring shop in an old Ford they were working on. The pipe broke off at both fittings and my task was to fabricate a pipe that would go around the obstacles in the engine. I also brazed on some flare fittings to make the tubing easier to install and disconnect in the future. |
Bookmarks |
|
|