000007008244 Dowel for harmonic balancer, Large Engine Application List
 

These pins are single use = once installed they are trash if removed...
* The pins should be driven into place with a hammer and BRASS drift.
* If the harmonic is installed correctly = not 180 degrees off, the pin will be cut slightly and deformed only enough to assume the exact size/shape of the retainer holes...

Item Number: 000007008244
Main Category: MB
Sub Category: Engine Mechanical
Description: Dowel, harmonic balancer...(two per engine), Application Engine: M110, 114, 115, 127, 130, 180, OM615, 616, 617, 661, 662.
Weight: 0.020

Two Dowel pins MB# 000007008244 are used on each of the following engines:

M110. 921, 922, 923, 924, 926, 931, 932, 932, 981, 982, 983, 984, 985, 986, 987, 988, 989, 990, 991, 992, 994

M114. 920

M115. 920, 951, 954

M127. 981, 982, 984

M130. 922, 925

M180. 922, 926, 927, 928, 929, 942, 943, 952, 953, 958

OM615. 912, 935

OM616. 910, 911, 912, 913, 914, 915, 916, 917, 918, 919, 930, 931, 932, 933, 934, 936, 937, 938, 939, 940, 943, 944, 963

OM617. 910, 912, 913, 919, 931, 932, 933, 950, 951, 952

OM661. 911

OM662. 911

* The cap screws holding the pulley to the harmonic balancer must be replaced with NEW, the old ones can shear off, dropping the pulley on the road to smash under your vehicle.

Harmonic pulley cap screws (six per engine), OM617.952 and 616.912 as of engine# 027799
MB# 000912008203

*********

SCREW, PULLEY TO HARMONIC BALANCER, (QUANTITY THREE PER ENGINE)
MB# 000912008201
APPLICATION: 616.912 AND 616.916, USED UP TO ENGINE 616.912: 086378 AND 616.912: 027798, ALSO USED UP TO ENGINE 616.916: 086378 AND 616.916: 027798...




NOTE – All prices on special order parts subject to change without notice.