All parts listed are for a W126 300SD unless otherwise noted:
Automatic transmission filter and pan seal kit, $30
Switches: Sunroof, power antenna, hazard (triangle symbol is worn off), window, $5 each Right hand power mirror switch -works- $10
Blower motor (2 available, work) $20 each
Electric vacuum pump (2 available that work) $20 each
Mono valve, works $20
Blower speed control module, $20
Temperature control module, $20

All these bits are safely tucked away in a plastic box so if you see this post a year from now, and I haven't posted the parts are gone, then I still have them.

Steering gearbox, on the bench at this moment getting new seals, nice and tight, $250
Center/drag link, replaced when I temporarily put the car on the road, about 500miles on it, $50
Front calipers, $50 for the pair
14" Bundts, five wheels total one with a nearly new tire, a couple do seem to have some curb rash now that I've inspected closely, make an offer, they are going with the car to scrap if nobody wants them.
Complete set of locks with ignition lock with key, key has rip in rubber part so it won't stay on a ring, $135.

If there's a price here you don't agree with, counter it. At worst I'll say no.

You can get the rubber head from Auto Haus in AZ for $5.61. Part number with them is 0007664406 - FYI

Well, that'll be good for whoever buys it. For right now, it's just sitting in the ignition lock.

I need to clean up around here, the hood, grille, bumper and fenders from this thing need to go. Not great, but not rusted, paint is shot. No dents. $150 or best offer for both fenders and hood with hinges and springs. I'm anticipating a scrap run in three weeks or so, if these aren't wanted by then they have to go.

Do you have bolts for the stock bundts?

__________________
'76 300D
'82 230CE
'84 300DT
'91 300D 2.5
'86 300D 5 speed
'86 250D 5 speed
'90 300E 24v
'88 560SEC
300TE euro 5 speed
91 350SD
http://i75.photobucket.com/albums/i3...d6605222-1.jpg

Nope, those went with the car.
Bundts are gone too.

I am looking for a working power antenna. If the one you have listed works and has a good/complete mast I am interested.

PM me

Thanks

__________________
08 R320 CDI current

Past
95 E420
87 300D Turbo 5spd
90 300TE
83 300SD
85 300TD
92 400E
85 190D

Do you still have the blower motor(s)?

__________________
'05 E320 CDI
'20 GLE 450

No power antenna- just the switch for one.

One blower motor gone.

Blower motor recieved and functional.

__________________
'05 E320 CDI
'20 GLE 450

Glad that worked for you-

The blower you sent works just not in my car right now. PO did some hacking when the blower quit but the problem lies in the ccu or blower control.

So about these
Mono valve, works $20
Blower speed control module, $20
Temperature control module, $20

Is the blower module the under dash unit that does the actual speed control? I may grab all 3 of these items for spares/trouble shooting the blower. Same shipping location 63367.

Side note: I had a CCU purchased from a local seller on ebay but apparently they must be dead. 2 weeks and no email or package.

__________________
'05 E320 CDI
'20 GLE 450

The little box on next to the blower motor that the motor plugs into is the speed control. It's similar to the resistor block that domestic cars used, the CCU sends power on one or more of the wires, and the speed control send the corresponding voltage to the blower motor. Speed control is right nearby.
They are tagged in German (naturally), the speed control is geblaserregler, part number 1147328026, and the temperature regulator is a silver box marked temperaturregler, part number 1147328023.
You may want to double check that these will work on your car, I'm not sure exactly when these parts changed.

Assuming it all is correct, all that will fit in a medium flat rate box, so $11 for shipping.