PeachParts Mercedes-Benz Forum

PeachParts Mercedes-Benz Forum (http://www.peachparts.com/shopforum/)
-   ML, GL, G-Wagen, R-Class, Unimog, Sprinter (http://www.peachparts.com/shopforum/ml-gl-g-wagen-r-class-unimog-sprinter/)
-   -   Emissions failed again (http://www.peachparts.com/shopforum/ml-gl-g-wagen-r-class-unimog-sprinter/203305-emissions-failed-again.html)

RAN 10-24-2007 11:45 AM

Emissions failed again
 
Hi,

I have a ML230 European and 6 Emissions -Failed this year.
I already change O2 sensor, catalytic converter, spark plugs and MAF.
I spend much money replacing the components and for what?
I already send the car to mercedes and no one can tell me what the problem is

6 Emissions -Failed

IDLE
Co = 1,13 must be <0,5%

3000RPM
Lambda close to the limit = 1,03

Could you help me please?
Thank you in advance

dieseldiehard 10-24-2007 05:37 PM

Total Spammer Total Spammer Total Spammer
 
TOTAL SPAMMER TOTAL SPAMMER TOTAL SPAMMER TOTAL SPAMMER TOTAL SPAMMER TOTAL SPAMMER TOTAL SPAMMER TOTAL SPAMMER TOTAL SPAMMER TOTAL SPAMMER TOTAL SPAMMER TOTAL SPAMMER TOTAL SPAMMER TOTAL SPAMMER TOTAL SPAMMER TOTAL SPAMMER TOTAL SPAMMER TOTAL SPAMMER TOTAL SPAMMER TOTAL SPAMMER TOTAL SPAMMER TOTAL SPAMMER TOTAL SPAMMER TOTAL SPAMMER TOTAL SPAMMER TOTAL SPAMMER TOTAL SPAMMER TOTAL SPAMMER TOTAL SPAMMER TOTAL SPAMMER
somebody please block this idiot

RAN 10-24-2007 05:45 PM

You are an idiot. I only need some help.

jfreezn 11-07-2007 01:33 PM

failed emissions
 
High CO would indicate a vacuum leak, has anyone put a vacuum gauge on the engine to see where it's at during idle. I would start by checking the rubber vacuum distribution fitting plugged in at the rear of the intake manifold, just to the drivers side of center. Part # 112-018-02-09 @ $9.25 for my 98 US ML320. IF this fitting is original, you will find it is crumbling and the syphon tube in the center has probably fallen off. it just pulls straight up to remove.

Another place to check is a small vacuum hose which plugs into the bottom of the intake manifold, front and center. Bad place for rotting hoses under there and you cannot even see where it plugs in. Remove the electric air pump for a little better access. You can feel the fitting and you will probably find one or more vacuum hoses in that area that are leaking.

I am assuming you have done the obvious, and that is to remove the EGR discharge pipe that goes into the intake manifold. The end of that pipe will be carboned up and blocking EGR.

Good luck,

Jim in Phoenix

jfreezn 11-19-2007 12:14 AM

It should go without saying that a progress report is always appreciated. Success breeds reinforcement and failure will usually get you more things to try. We all learn, either way!

Jim in Phoenix


All times are GMT -4. The time now is 02:46 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website