Just thought I'd post since I am having trouble finding one and thought maybe someone here had one by chance.

Tom

__________________
[SIGPIC] Diesel loving autocrossing grandpa Architect. 08 Dodge 3/4 ton with Cummins & six speed; I have had about 35 benzes. I have a 39 Studebaker Coupe Express pickup in which I have had installed a 617 turbo and a five speed manual.[SIGPIC]

..I also have a 427 Cobra replica with an aluminum chassis.

PN# MB408473

MB408473 - OEM Mitsubishi

$36.02

__________________
1987 560SL
85,000 miles

Thanks Jon! I tried that website already and the part is no longer available....neither at about six other sites appearing to offer them....some sites had them shown but someplace on the page it says no longer available.

Perhaps a used one....?

__________________
[SIGPIC] Diesel loving autocrossing grandpa Architect. 08 Dodge 3/4 ton with Cummins & six speed; I have had about 35 benzes. I have a 39 Studebaker Coupe Express pickup in which I have had installed a 617 turbo and a five speed manual.[SIGPIC]

..I also have a 427 Cobra replica with an aluminum chassis.

Have you cross referenced for the same part for the 1987 Dodge Raider?

__________________
1987 560SL
85,000 miles

At least that will open you up to another option since it looks like you're going to have to go the scavenger route, and contact salvage yards.

__________________
1987 560SL
85,000 miles

Don't forget that the Montero was sold as the Pajero in other countries...

I believe the parts vendors lump all those together automatically. I ordered one later from Amazon. Probably don't have it though.

Thanks guys!

__________________
[SIGPIC] Diesel loving autocrossing grandpa Architect. 08 Dodge 3/4 ton with Cummins & six speed; I have had about 35 benzes. I have a 39 Studebaker Coupe Express pickup in which I have had installed a 617 turbo and a five speed manual.[SIGPIC]

..I also have a 427 Cobra replica with an aluminum chassis.

Did you check these guys out?

replacement Gauge in stock.

I did, and just for kicks I ordered one from them too. It'll be interesting to see what happens.

__________________
[SIGPIC] Diesel loving autocrossing grandpa Architect. 08 Dodge 3/4 ton with Cummins & six speed; I have had about 35 benzes. I have a 39 Studebaker Coupe Express pickup in which I have had installed a 617 turbo and a five speed manual.[SIGPIC]

..I also have a 427 Cobra replica with an aluminum chassis.

try ebay in other countries.Americans usally trade every 6 years,cause vehicles don't last here.

__________________
1999 w140, quit voting to old, and to old to fight, a god damned veteran

I had one of these once. Not a bad ride for a 4x4.

You can call up a web site called Row52 and it will allow you to search for cars in wrecking yards in your area. If you need anything else for it you might want to check this site out.

Be sure to replace the gasket. According to other owners I spoke with the gasket on the fuel sending unit is prone to leaking and needs to be replaced every now and then.

This is easy to get to after you remove about one million bolts that hold the rear carpet in. The access plate is also held down by bolts that must have been put in with Loctite Blue so get out the big cheater bar.

Mine is carburated and the sender is accessible from below. I got an email from Amazon saying they have shipped the part already.....does that mean it really exists?

__________________
[SIGPIC] Diesel loving autocrossing grandpa Architect. 08 Dodge 3/4 ton with Cummins & six speed; I have had about 35 benzes. I have a 39 Studebaker Coupe Express pickup in which I have had installed a 617 turbo and a five speed manual.[SIGPIC]

..I also have a 427 Cobra replica with an aluminum chassis.

Not necessarily...they've been known to have items marked wrong. My last mishap with them was an intake manifold for a Ford 302. What was sent wasn't even for a V8. I sent it back, and picked one up locally, instead.

Hopefully your experience is a positive one. Thoroughly compare the two to make sure it's the right one. I was getting ready to suggest that you research to see if they used the same unit with modifications in other vehicles...and if so, to get one and see if you can alter to fit your application.

__________________
1987 560SL
85,000 miles

Yeah, good idea. Thanks Jon!

__________________
[SIGPIC] Diesel loving autocrossing grandpa Architect. 08 Dodge 3/4 ton with Cummins & six speed; I have had about 35 benzes. I have a 39 Studebaker Coupe Express pickup in which I have had installed a 617 turbo and a five speed manual.[SIGPIC]

..I also have a 427 Cobra replica with an aluminum chassis.

Hey Tom,

Hopefully they are sending you the right part and it works out. For what its worth, I wonder if your part may be repairable. I recently repaired a W126 unit that has been NLA for a while now. It wasn't bad at all. It's basically a float running along some wires that varies resistance to ground.

W126 Fuel Level Sender Repair - Album on Imgur

__________________
Cruise Control not working? Send me PM or email (jamesdean59@gmail.com). I might be able to help out.
Check here for compatibility, diagnostics, and availability!

(4/11/2020: Hi Everyone! I am still taking orders and replying to emails/PMs/etc, I appreciate your patience in these crazy times. Stay safe and healthy!)


82 300SD 145k
89 420SEL 210k
89 560SEL 118k
90 300SE 262k RIP 5/25/2010
90 560SEL 154k
91 300D 2.5 Turbo. 241k
93 190E 3.0 235k
93 300E 195k