Ok, now i have done some test runs and tested out a few things.
With fixed timing on, the tooth 1 should be at 98 degrees shows the timing light.
When setting it back to use table the exhaust temp rises fast up to 450-500 degrees when over 3500 rpm.
But if i put tooth 1 at 90-92 degrees the exhaust temp doesnt rise so fast and it drops down faster.
Acording to turbobandit the timing should be 102 when counting the teeth to get the degrees. Was running on that degree on tooth 1 earlyer but then the exhaust temp was sky high!..

Ok! So now i got some new stuff ready to be installed! One of the things are new injectors.
These are 1000cc low ohm injectors, about 2.2 ohm i think. So woundering if these resistors would work?
https://www.ebay.com/itm/162015704966