Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Search Forums

Showing results 1 to 30 of 148
Search took 0.02 seconds.
Search: Posts Made By: Meza
Forum: Diesel Discussion 09-10-2004, 06:22 PM
Replies: 0
Views: 938
Posted By Meza
If you have a 300TD station wagon, 240D, 280E, and 300D 1975-86 Sedan Check this

Two complete leather upholstry kit for front seats on ebay for $199. A hell of a deal!! :) :)
Copy and Paste the link below. I already bought a kit for my Bimmer for only $69.00 shipped both front...
Forum: Tech Help 08-01-2004, 09:21 PM
Replies: 8
Views: 2,092
Posted By Meza
Sounds like a coolant temp sensor problem. Check...

Sounds like a coolant temp sensor problem. Check the resistance at different temperature.
Good luck,
Meza
Forum: Tech Help 08-01-2004, 09:01 PM
Replies: 2
Views: 676
Posted By Meza
Problem solved..

The coolant temperature sensor was disconnected from an earlier work on the car. Once connected, the duty cycle was fluctuating around 50% like it supposed to. Thanks for all the help.
Meza
Forum: Tech Help 07-30-2004, 12:07 AM
Replies: 2
Views: 676
Posted By Meza
On-off 70 % ratio Readout !

This is what I get when I check for duty cycle at pin 3 of the X11 connector with the engine running. It's a 93 190E 2.6L engine. Definition to this code is: (Implausable TNA-signal (rpm signal) at...
Forum: Tech Help 06-20-2004, 11:28 PM
Replies: 12
Views: 5,644
Posted By Meza
It took about two hours to figure it out. My rear...

It took about two hours to figure it out. My rear driver side was bad and taking the door panel out wasn't much help. I am glad everything worked out fine.
Meza
Forum: Tech Help 06-20-2004, 11:01 PM
Replies: 12
Views: 5,644
Posted By Meza
Just what I posted.. I hope that helped.

Just what I posted.. I hope that helped.
Forum: Tech Help 06-19-2004, 12:07 AM
Replies: 3
Views: 1,223
Posted By Meza
Do a search.. There is a TON of info on that...

Do a search.. There is a TON of info on that subject. I think you're problem is on the OVP relay. Do a search on that too.
Good luck,
Meza
Forum: Tech Help 06-18-2004, 11:56 PM
Replies: 1
Views: 718
Posted By Meza
To remove the radiator, you must remove the front...

To remove the radiator, you must remove the front bumper.
There are (4) 13 mm hex-nuts holding the bumper inplace. 2 at each bracket. Make sure you remove the air bag sensor that is attached to the...
Forum: Tech Help 06-18-2004, 06:09 PM
Replies: 2
Views: 1,593
Posted By Meza
Bump!!

Bump!!
Forum: Tech Help 06-18-2004, 12:45 AM
Replies: 6
Views: 1,022
Posted By Meza
Yes there is a way!

Yes the master cylinder can leak into your booster and it's very common. As a matter of fact, booster that have traces of brake fluid in them can not be taken back for a core charge. If your booster...
Forum: Tech Help 06-18-2004, 12:37 AM
Replies: 2
Views: 1,593
Posted By Meza
190e vacuum modulator replacement question..

I have a new modulator that I need to install. I know it can not be installed unless the tranny is lowered. My question is : Does it need adjustment after installation or install and leave it alone...
Forum: Tech Help 06-17-2004, 01:01 AM
Replies: 2
Views: 744
Posted By Meza
BMWs by design have a slight negative camber. and...

BMWs by design have a slight negative camber. and it is not adjustable. Only replacement of of trailing arm bushing would correct the problem. With age the camber increases and does wear the tires...
Forum: Tech Help 06-15-2004, 11:37 PM
Replies: 3
Views: 828
Posted By Meza
Did you find the problem?

I do have the same problem with your same description on my 93 190e 2.6L. Please keep us updated. I haven't looked closely at mine, but I am guessing it's one of the CV joints. Outer one (closer to...
Forum: Tech Help 04-02-2004, 06:54 PM
Replies: 4
Views: 1,003
Posted By Meza
Well, I never had any of the brake lines open. I...

Well, I never had any of the brake lines open. I just removed the old fluid from brake reserevoir and filled it with fresh DOT4 and bled all four calipers. fluid came out nice and no air that I can...
Forum: Tech Help 04-02-2004, 06:36 PM
Replies: 9
Views: 1,362
Posted By Meza
I am doing it in my garage. No welding involved....

I am doing it in my garage. No welding involved. Just bolts, nuts, and gaskets. I would assume no more than an hour at a muffler shop. Actually, on the 190e, It looks much easier than my BMW. I have...
Forum: Tech Help 04-01-2004, 09:48 PM
Replies: 4
Views: 1,003
Posted By Meza
Brake experts..Some help needed on my 190e brakes

The car is a 93 2.6L 190E.
I have done over 50 brake jobs on many cars. My wife drives the car and I hardly drive it. Until I drove it to Charleston, SC over a weekend and the damn thing would not...
Forum: Tech Help 04-01-2004, 09:25 PM
Replies: 12
Views: 5,644
Posted By Meza
I know what happened

because it happened in my 190e. All you need to do is rotate the white guide 180 degrees from the sheet metal piece behind it. I can't remember CCW or CW. Go with the direction that extend the window...
Forum: Tech Help 04-01-2004, 09:04 PM
Replies: 9
Views: 1,362
Posted By Meza
I got one for my 535i BMW last week from...

I got one for my 535i BMW last week from Autopartsauthority.com
For a 190e 2.6L it is: 326.00 free S&H made by DEC (best fit and sound compared to OEM among all aftermarket cats.
...
Forum: Tech Help 03-19-2004, 07:40 PM
Replies: 4
Views: 1,262
Posted By Meza
I have the same problem on my 190e 2.6L

I am curious to find what's causing it..
Forum: Tech Help 09-23-2003, 07:18 PM
Replies: 13
Views: 3,931
Posted By Meza
Correction! The fuel pump comes on while cranking...

Correction! The fuel pump comes on while cranking and not by having the ignition on by it self. You must jumper I believe (check!) 30 and 87 at the fuel pump relay connector to activate the pump. No...
Forum: Tech Help 09-23-2003, 12:53 AM
Replies: 1
Views: 712
Posted By Meza
Get the original MB manual. Check Fastlane or...

Get the original MB manual. Check Fastlane or E-bay.
Forum: Tech Help 09-23-2003, 12:48 AM
Replies: 20
Views: 3,927
Posted By Meza
It happened to me on my 93 190e 2.6. I had to do...

It happened to me on my 93 190e 2.6. I had to do it 3 times before I got it to seal. The surfaces have to be very clean and you must tighten the bolts evenly and really snug to get them to seal the...
Forum: Tech Help 09-23-2003, 12:08 AM
Replies: 7
Views: 3,927
Posted By Meza
As far as I know, a new fuel pump comes with a...

As far as I know, a new fuel pump comes with a new check valve. If you changed your pump, then you have a new valve. Your problem is related to what is called " Rest Pressure" or the ability of the...
Forum: Tech Help 09-12-2003, 08:27 PM
Replies: 3
Views: 1,447
Posted By Meza
Send me a fax # and I will send you the procedure.

Send me a fax # and I will send you the procedure.
Forum: Tech Help 09-07-2003, 02:45 AM
Replies: 9
Views: 2,538
Posted By Meza
If you have a carquest auto part store in your...

If you have a carquest auto part store in your area go there as they have the 12 point you're looking for.
Good Luck,
Meza
Forum: Tech Help 09-06-2003, 05:48 PM
Replies: 1
Views: 733
Posted By Meza
1993 190e fan switch light ! Is there one, or is it dark by default?

I noticed that the fan switch (below the center vents) has no lights to show the position. Is this normal? If not, where is the bulb located?
Thanks,
Meza
Forum: Tech Help 09-06-2003, 05:16 PM
Replies: 13
Views: 2,219
Posted By Meza
I beleive your belt is way past due. I suggest...

I beleive your belt is way past due. I suggest you change it ASAP. Just my 0.02 cents
Forum: Tech Help 09-06-2003, 02:12 PM
Replies: 31
Views: 3,133
Posted By Meza
Cap'n Carageous, I see you live in Georgia. Why...

Cap'n Carageous, I see you live in Georgia. Why don't you drive the car or tow it to Steve B? Just a suggestion.
Meza
Forum: Tech Help 09-04-2003, 09:47 PM
Replies: 1
Views: 607
Posted By Meza
Bump!

Anyone!
Forum: Tech Help 09-01-2003, 09:49 PM
Replies: 11
Views: 2,024
Posted By Meza
Problem Solved

I finally solved the low power problem with the car that I experienced after rebuilding the head. It was found by accident. I finally had some time and decided to take the valve cover and check the...
Showing results 1 to 30 of 148

 
Forum Jump


All times are GMT -4. The time now is 06:50 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2018 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page