Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Search Forums

Showing results 1 to 30 of 101
Search took 0.02 seconds.
Search: Posts Made By: ragtopper
Forum: Mercedes-Benz SL Discussion Forum 02-26-2017, 09:16 PM
Replies: 4
Views: 1,422
Posted By ragtopper
97 - yes. I keep charger on it as it has...

97 - yes. I keep charger on it as it has parasitic drain. Perhaps an overcharged low battery.
Anyone suspect collateral damage?

Ragtopper
1982 380SL
Forum: Mercedes-Benz SL Discussion Forum 02-26-2017, 12:44 PM
Replies: 4
Views: 1,422
Posted By ragtopper
Battery go BOOM!

Latest issue: Recent replacement of dist cap, rotor, ICU (ICU seemed to fix non-start issue, but engine now smoking - see other post).

Battery been on charger. Went to crank & soon as I turned...
Forum: Mercedes-Benz SL Discussion Forum 02-10-2017, 05:36 PM
Replies: 3
Views: 1,158
Posted By ragtopper
Just went through this. Twice. Ignition Control...

Just went through this. Twice. Ignition Control Unit, I'll bet. Front driver side fender. Bought a Hueco unit lasted about a year, then died.
Just bought Programa remanufactured Bosche for $80....
Forum: Mercedes-Benz SL Discussion Forum 02-10-2017, 02:45 PM
Replies: 2
Views: 1,069
Posted By ragtopper
Folks, Any ideas re smoke from rear of...

Folks,
Any ideas re smoke from rear of manifold? (Below where it attaches to head). Gasket?? etc?
Any thoughts / help appreciated.

Ragtop
1982 380SL
Forum: Mercedes-Benz SL Discussion Forum 02-05-2017, 05:10 PM
Replies: 2
Views: 1,069
Posted By ragtopper
380sl smoking / screeching

Latest issue:
Had a non-start issue. Changed distributor & rotor and turned out to be bad Hueco replacement ICU. Replaced w Bosch & cranked right up. (Been sitting since October).

Now, lot of...
Forum: Mercedes-Benz SL Discussion Forum 11-13-2016, 12:24 PM
Replies: 4
Views: 1,628
Posted By ragtopper
Thx D300. The pump wont run when cranking....

Thx D300.
The pump wont run when cranking. Again - however, it will run if I jumper pin slots 7 & 8. When pump DID run, I could hear it buzz for a few seconds before car would start. FP relay is...
Forum: Mercedes-Benz SL Discussion Forum 11-10-2016, 10:05 AM
Replies: 4
Views: 1,628
Posted By ragtopper
Thx for reply, J. Will go thru checklist. ...

Thx for reply, J.
Will go thru checklist.
Also just remembered: a few months ago, had issue with fuel leaking from gas cap after fillup. Assumed gas cap gasket bad so replaced with new cap. Now...
Forum: Mercedes-Benz SL Discussion Forum 11-06-2016, 03:43 PM
Replies: 4
Views: 1,628
Posted By ragtopper
New FP relay, pump runs when jumped. But...

Once again, cranks but wont start...
Jumped relay (pins 7 & 8) and fuel pump indeed runs (but wont start car). Plugged in NEW FP relay - but pump wont run when key turned.
Further: Sprayed a little...
Forum: Mercedes-Benz SL Discussion Forum 10-08-2016, 11:51 AM
Replies: 5
Views: 1,344
Posted By ragtopper
WHEN to check for milky oil..hot vs cold? Make a difference?

Checked oil yesterday after car been running a 10 -15 minutes. Oil appeared milky & runny (thin viscosity).
Checked oil (cold) this am and was crystal clear amber. Coolant appears clear too.
My...
Forum: Mercedes-Benz SL Discussion Forum 04-18-2015, 05:07 PM
Replies: 1
Views: 726
Posted By ragtopper
Cranky SL wont crank.

Story: Got in habit of letting 82 380SL "warm up" for about 10 mins. Recently, went out to drive and car had died with ignition still on. Wouldnt restart (crank but no start).
Read somewhere...
Forum: Tech Help 03-13-2015, 11:11 AM
Replies: 18
Views: 9,577
Posted By ragtopper
Thermal grease??

Just got the Huco Ignition Control Module replacement part, which came with small tube of white thermal grease. Can someone answer this:

Is the thermal grease applied between the ICM black...
Forum: Mercedes-Benz Used Parts For Sale & Wanted 02-03-2015, 10:32 PM
Replies: 4
Views: 512
Posted By ragtopper
Thx for checking Ron. And take your time. I'll...

Thx for checking Ron. And take your time. I'll be offline for about a week.
Ragtopper
1982 380SL
Forum: Mercedes-Benz Used Parts For Sale & Wanted 02-02-2015, 02:36 PM
Replies: 4
Views: 512
Posted By ragtopper
WTB / NEED: Ignition Control Module ICM for 1982 380SL

Yep - ICM finally crapped out. Bosch # 0227 100 042.
Any help appreciated.

Ragtopper
1982 380SL
Germantown TN
Forum: Mercedes-Benz Used Parts For Sale & Wanted 03-26-2014, 09:57 AM
Replies: 2
Views: 653
Posted By ragtopper
<bump> Hell, put a coffee table between em and...

<bump> Hell, put a coffee table between em and furnish your kids' dorm. :)

Ragtopper
1982 380SL
Forum: Mercedes-Benz Used Parts For Sale & Wanted 02-06-2014, 12:13 PM
Replies: 2
Views: 653
Posted By ragtopper
still got em. Would hate to put em on the curb,...

still got em. Would hate to put em on the curb, as they've kept me upright for over 10 years. Sentimental seating... :)

Ragtopper
1982 380SL
Forum: Mercedes-Benz Used Parts For Sale & Wanted 01-21-2014, 07:39 PM
Replies: 2
Views: 653
Posted By ragtopper
380SL Seats - rough...

These came out of my 82 380sl. Leather. Maybe someone could use for rebuild project, etc. I had MB sheepskins over these.
Make an offer if interested. PM me.
I'm in Memphis TN (will also list...
Forum: Mercedes-Benz SL Discussion Forum 11-14-2013, 10:03 AM
Replies: 3
Views: 1,171
Posted By ragtopper
Rails too?

Thanks Rowdie. Next question: Since rails are identical, would you recommend leaving existing 380 rails, and simply inserting 560 seats into these? (And hope I dont lose plastic parts, etc). Or,...
Forum: Mercedes-Benz SL Discussion Forum 10-23-2013, 11:25 AM
Replies: 3
Views: 1,171
Posted By ragtopper
Help IDing these seats???

Just procurred these seats to replace the tattered ones in my 380SL. My research tells me they're from a 560SL. (Car no longer exists, so I cant check VIN #). Want to start clean-up process before...
Forum: Mercedes-Benz SL Discussion Forum 06-15-2013, 01:31 PM
Replies: 3
Views: 1,300
Posted By ragtopper
solution?

Think I figured it out. Seems it was attached to bottom metal rail of window, maybe as a spacer or something?? (Found some of the green, rubbery substance had rubbed off on inside bottom of door). ...
Forum: Mercedes-Benz SL Discussion Forum 06-15-2013, 01:00 PM
Replies: 3
Views: 1,300
Posted By ragtopper
Can you identify this window/door part?

Have passenger door panel off (82 380SL), troubleshooting an annoying *thunk* inside panel. Found this loose part at bottom of inside door. Looks like it might hold window as the L-shaped "hook"...
Forum: Mercedes-Benz SL Discussion Forum 04-17-2010, 06:45 PM
Replies: 25
Views: 4,007
Posted By ragtopper
FOLLOW UP

As (hopefully) a final follow-up on this debacle, I opted to put in shop and let them try and find the cause of the high idle.
Turns out the remanufactured Idle Control Unit I purchased was...
Forum: Mercedes-Benz SL Discussion Forum 03-29-2010, 07:22 PM
Replies: 25
Views: 4,007
Posted By ragtopper
Voltage at diagnostic socket pins 2 & 3 ranges...

Voltage at diagnostic socket pins 2 & 3 ranges from 10.4 to 11v.

Idles good until air pump kicks in, then starts missing / rising as engine warms.

I also took your advice and sprayed more carb...
Forum: Mercedes-Benz SL Discussion Forum 03-29-2010, 11:30 AM
Replies: 25
Views: 4,007
Posted By ragtopper
Thx for hanging w/me on this Chuck. Yes, it is...

Thx for hanging w/me on this Chuck. Yes, it is indeed frustrating....
I will try to find F7 (?) as well as diagnostic socket(?) and test.

Have sprayed carb cleaner around vac lines/connectors,...
Forum: Mercedes-Benz SL Discussion Forum 03-27-2010, 04:56 PM
Replies: 25
Views: 4,007
Posted By ragtopper
Got it. Getting 12v to terminal on fender. At...

Got it. Getting 12v to terminal on fender.
At cold start, idles 550. At warm, after driving 20 mins, idle stays at around 1100 (in neutral). Rechecked OVP sockets - clean.
Removed the little...
Forum: Mercedes-Benz SL Discussion Forum 03-27-2010, 03:24 PM
Replies: 25
Views: 4,007
Posted By ragtopper
Somewhat of an update... Had battery tested at...

Somewhat of an update...
Had battery tested at AZ, they said it was fully charged. Replaced negative battery cable anyway.
OVP & ICunit both getting 12.4v (my meter).
IC valve (at pins)...
Forum: Mercedes-Benz SL Discussion Forum 03-22-2010, 08:10 PM
Replies: 25
Views: 4,007
Posted By ragtopper
uh oh. Negative battery cable occasionally pops...

uh oh.
Negative battery cable occasionally pops off post as the female connector is somewhat "out of round".

Surely this isnt causing all the grief....

say it aint so.


Ragtopper
1982...
Forum: Mercedes-Benz SL Discussion Forum 03-22-2010, 01:50 PM
Replies: 25
Views: 4,007
Posted By ragtopper
Getting 12.2 volts with engine running. ...

Getting 12.2 volts with engine running.

Ragtopper
1982 380SL
Forum: Mercedes-Benz SL Discussion Forum 03-21-2010, 02:38 PM
Replies: 25
Views: 4,007
Posted By ragtopper
Chuck, I'm getting 10.7v from main battery, which...

Chuck, I'm getting 10.7v from main battery, which is consistent w/OVP and ICU.
Time to replace battery?

Ragtopper
1982 380SL
Forum: Mercedes-Benz SL Discussion Forum 03-20-2010, 04:37 PM
Replies: 25
Views: 4,007
Posted By ragtopper
Getting 10.7 volts from OVP socket (#1) and same...

Getting 10.7 volts from OVP socket (#1) and same to ICU harness (#2 & 4).
Should be sufficient, eh?
Idles perfect at 550 at startup, but increases to approx 1100 when warm.

Ragtopper
1982...
Forum: Mercedes-Benz SL Discussion Forum 03-20-2010, 03:36 PM
Replies: 25
Views: 4,007
Posted By ragtopper
Just unplugged OVP again, reattached and now...

Just unplugged OVP again, reattached and now getting 10.4 volts to ICU harness.
What gives?

Ragtopper
1982 380SL
Showing results 1 to 30 of 101

 
Forum Jump


All times are GMT -4. The time now is 07:47 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page