Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Search Forums

Showing results 1 to 21 of 21
Search took 0.01 seconds.
Search: Posts Made By: gasser
Forum: Mercedes-Benz SL Discussion Forum 03-07-2006, 03:06 PM
Replies: 0
Views: 814
Posted By gasser
No spark

91 500SL At times will start but most of the time there is no spark when this happens cannot communicate DI/AZK control unit, when does run can read codes no codes most of the time sometimes get a...
Forum: Tech Help 02-15-2006, 11:44 AM
Replies: 0
Views: 703
Posted By gasser
91 500sl ignition

Car had a bad EZL module but the only way to get the car running is to reset the engine module through the push button (clear codes) even though no codes are stored (california model) could this be a...
Forum: Tech Help 01-05-2006, 03:16 PM
Replies: 0
Views: 853
Posted By gasser
91 500sl no spark

Hi anybody out there w/idea no RPM code #7 to (e3) cfi, Does this signal come from EZL? I have done a pin check on EZL and all is well Have tried a known good unit from wrecking yard does not work,...
Forum: Tech Help 01-03-2006, 08:55 PM
Replies: 1
Views: 684
Posted By gasser
No Primary ignition

Help I have a 91 500SL, no spark Test at #1 post on coils no waveform, test crk and cmp sensors ok, pin test ignition module all good, try 2 known good modules nothing, try to pull code in engine ECU...
Forum: Tech Help 01-03-2006, 08:45 PM
Replies: 1
Views: 1,011
Posted By gasser
Crank sensor

Hi the crank sensor can be tested w/ohm test but the best way, that will also test pins on flywheel is w/waveform viewer. With a waveform viewer you unplug sensor and hook straight to it. I use a...
Forum: Tech Help 04-04-2005, 01:40 PM
Replies: 0
Views: 649
Posted By gasser
94 600sl mirrows

Hi have a strange problem when operating mirrows the rear view mirrow moves to the left and no up and down on the outside mirrows and sometimes the st. wheel moves. Has new mirrow switch maybe...
Forum: Tech Help 03-31-2005, 08:44 PM
Replies: 2
Views: 764
Posted By gasser
Abs lite

Well I tried a new switch and still same problem, I can start car and drive w/switch closed and lite stays off I can do the same w/switch open and lite stays off, but if i put switch back in and...
Forum: Tech Help 03-29-2005, 07:25 PM
Replies: 2
Views: 764
Posted By gasser
ABS lite

Hi I have a 94 600sl in my shop w/abs lite coming on only when braking while moving, the code I get is for the abs solenoid relay, tryed a new relay still have problem. Pin checked the ecu and all is...
Forum: Tech Help 02-12-2005, 11:25 AM
Replies: 3
Views: 922
Posted By gasser
abs problem

I'm going try these relays and see what happens, would I not get a code for wheel sensor instead of solenoid relay? Thamks for your responce and will keep updated
Forum: Tech Help 02-11-2005, 08:32 PM
Replies: 3
Views: 922
Posted By gasser
abs problem

94 600sl drive car 20 feet abs /asr lite comes on found code 12 solenoid valve relay asr works fine and no codes in ea/cc/isc control unit. Is the problem just a relay? I ordered both of them since...
Forum: Tech Help 11-18-2004, 01:43 PM
Replies: 1
Views: 561
Posted By gasser
ECU Wanted

Hi I'm looking for the EA/CC/ISC or EGAS control unit for a 94 600SL
Thanks for any help George at Sandera's Auto Works (707)725-6321
Forum: Tech Help 11-17-2004, 10:03 AM
Replies: 2
Views: 1,195
Posted By gasser
ASR reset

Thanks for the reply,Year 1994 600SL. I have a shop so I got wholesale prices a L side $2840 and R side $2340. I tried to repair the wiring on the left one but did not touch the right on both have...
Forum: Tech Help 11-16-2004, 11:49 AM
Replies: 2
Views: 1,195
Posted By gasser
ASR Reset?

Hi I had to intall 2 new acccuators on a 600SL question: does the ECU need to be reset? Thanks for any help
George
Forum: Tech Help 11-15-2004, 08:37 PM
Replies: 3
Views: 719
Posted By gasser
Asr Ecu

94 600 SL Found two bad accuators bare wires.Wires were touching, all of them!! Question can this damage control unit? Thanks for any help George
Forum: Tech Help 10-11-2004, 12:28 PM
Replies: 7
Asr
Views: 951
Posted By gasser
asr connector

Thanks again for your time, here is a picture of the connector.
Forum: Tech Help 10-08-2004, 11:50 AM
Replies: 7
Asr
Views: 951
Posted By gasser
asr wiring

Hi and thanks for the reply,
The Vin#WDBFA76E3RF088893. Question the loom in question is the one that is part of the Actuator (sodered to a curcuit board inside) are we talking about the same...
Forum: Tech Help 10-05-2004, 09:46 PM
Replies: 7
Asr
Views: 951
Posted By gasser
Unhappy Asr

Howdy,
On a 94 600 SL Ihave a actuator problem took the covers off and found the wiring had turned to dust. I cut open the rest of the loom and found it was all dust!!! My question has anybody tried...
Forum: Tech Help 09-05-2004, 11:48 AM
Replies: 0
Views: 589
Posted By gasser
LED Button

Hello anyone

i have in my Shop a 94 600sl and near the can cus id a led button w/two sockets. I get a code out of it (16) and think it's the code for the vss sensor, or hope it is being that the...
Forum: Mercedes-Benz SL Discussion Forum 09-04-2004, 01:32 PM
Replies: 5
Views: 1,213
Posted By gasser
ASR Bypass

Hi Thanks fot the reply
Looks like I have no way of pulling the codes so i have seen where some have bypassed by taping off connectors 37,35,and 25 on a 500SL will this work on a 600SL (94) I tryed...
Forum: Tech Help 08-31-2004, 09:36 PM
Replies: 0
Views: 632
Posted By gasser
ASR pulling codes

I have a 94 600SL in my shop that has been to Dealers and shops who have tried many parts. My problem is that my scan tools may no work. I have the Snap-On and new OTC both w/Mercedes software. I can...
Forum: Mercedes-Benz SL Discussion Forum 08-30-2004, 11:01 PM
Replies: 5
Views: 1,213
Posted By gasser
ASR Lite

Hi I have a 94 600SL in my shop that has been to a Dealer and other shops for this ASR problem. He is a friend but that my change in the future :) My dilema is reading the codes, I have a Snap-On and...
Showing results 1 to 21 of 21

 
Forum Jump


All times are GMT -4. The time now is 07:34 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page