Porsche
/
BMW
/
Mercedes
/
Audi
/
Volkswagen
/
Saab
/
Volvo
/
MINI
All
Search Everything
Cart
|
Project List
|
Order Status
|
Help
Shop by Brand
/
Shop by Category
PeachParts Mercedes-Benz Forum
>
Search Forums
Search Results
User Name
Remember Me?
Password
Register
ShopForum Gallery
FAQ
Calendar
Search
Today's Posts
Mark Forums Read
Showing results 1 to 23 of 23
Search took
0.01
seconds.
Search:
Posts Made By:
merc380sel
Forum:
Tech Help
12-26-2004, 02:04 AM
Replies:
7
190e stalling on steep slope (forward only)
Views:
1,125
Posted By
merc380sel
How then should I clean the fuel tank?
Is this going to be an expensive job - fishing out the masking tape????
Forum:
Tech Help
12-25-2004, 08:59 PM
Replies:
7
190e stalling on steep slope (forward only)
Views:
1,125
Posted By
merc380sel
190e stalling on steep slope (forward only)
This is my 3rd post here regarding this problem.
Replaced ICV,OVP and Fuel Pump Relay and also checked speed sensor and all wirings as suggested by Steve and Jackd.
My 190e still stalls when...
Forum:
Tech Help
12-20-2004, 05:43 PM
Replies:
1
Will transmission problem causes stalling?
Views:
1,277
Posted By
merc380sel
Will transmission problem causes stalling?
I have a 190e which still is stalling after replacing OVP, ICV and Fuel Pump Relay.
Car still stalls occasionally when and after down shifting to low gear during stopping.
I can feel that the shift...
Forum:
Tech Help
12-10-2004, 05:52 PM
Replies:
2
190e still stalling! Please help, Steve or Anyone.
Views:
781
Posted By
merc380sel
Speed Sensor
Thanks very much for the quick reply.
Is the sensor attached to the speedo unit - need to replace the whole thing?
Or is it a seperate unit altogether?
How does it look like?
If I pull the...
Forum:
Tech Help
12-10-2004, 05:18 PM
Replies:
2
190e still stalling! Please help, Steve or Anyone.
Views:
781
Posted By
merc380sel
190e still stalling! Please help, Steve or Anyone.
I have a 1989 W210 190e 2.0 (similar to 2.3 model) in Australia.
Replaced OVP, Idle Control Valve and Fuel Relay Pump.
Engine still cuts off when the tranny down shifted to lower gear and the rpm...
Forum:
Tech Help
01-25-2002, 02:20 AM
Replies:
2
auxillary fan wouldn't stop running.
Views:
884
Posted By
merc380sel
auxillary fan wouldn't stop running.
The aux fan (aircondition) keeps running even after I pulled the ignition key out on my 85 380sel. I only realised after trying to start the car and the battery was flat.
I had to replaced the...
Forum:
Tech Help
09-10-2001, 02:41 AM
Replies:
0
380sel throttle switch
Views:
738
Posted By
merc380sel
380sel throttle switch
How do you know when the throttle switch is not working.
I tried disconnecting the 2 pin connector to the switch while the engine is running and noticed the idle rpm remain the same.
Also, is it...
Forum:
Tech Help
08-21-2001, 08:58 AM
Replies:
7
W126 idle speed control unit
Views:
7,147
Posted By
merc380sel
thanks again Steve! manage to locate the...
thanks again Steve!
manage to locate the plastic restriction in the the valve (top one).
I will try to adjust the restrictor opening smaller to bring the rpm down to about 650 untill I replace the...
Forum:
Tech Help
08-21-2001, 03:08 AM
Replies:
7
W126 idle speed control unit
Views:
7,147
Posted By
merc380sel
thank you Steve for your reply! thank you Peter...
thank you Steve for your reply! thank you Peter also!
where can I locate the restriction (broom handle) if it is put in?
where precisely is the idle hose.
is it easy to reverse it back.
will I...
Forum:
Tech Help
08-20-2001, 07:56 PM
Replies:
7
W126 idle speed control unit
Views:
7,147
Posted By
merc380sel
W126 idle speed control unit
I check the idle control unit which was located under the dash board today because the car was still idling around 900rpm after I replaced the idle speed actuator.
To my surprise, I noticed that the...
Forum:
Tech Help
08-03-2001, 05:09 AM
Replies:
23
Car wont go into forward gear/ only reverse help!!
Views:
25,699
Posted By
merc380sel
Hi BB, I lived in Sydney but would like to...
Hi BB,
I lived in Sydney but would like to enquire about some parts for my W126. Can you supply me your Melbourne mechanic contacts? Thanks!
Forum:
Tech Help
06-19-2001, 04:53 AM
Replies:
3
Pls Help, Steve! W126 Tranny problem
Views:
987
Posted By
merc380sel
Hi Steve, when shifting from D to R or R to D,...
Hi Steve,
when shifting from D to R or R to D, the rpm will surge over 1500rpm for 1 to 2 secs before engaging back to R. Is this slipage or flairing? It also happened on every disengaging( from D...
Forum:
Tech Help
05-24-2001, 03:56 AM
Replies:
3
OVP relay
Views:
1,284
Posted By
merc380sel
My 85 380sel (Euro) OVP Relay part number is 126...
My 85 380sel (Euro) OVP Relay part number is 126 540 47 45 located in the fuse box with a red 10 amp fuse on top.
I hope this helps!
Forum:
Tech Help
05-20-2001, 05:20 AM
Replies:
2
RPM goes up during gear change
Views:
759
Posted By
merc380sel
Forum:
Tech Help
05-19-2001, 07:28 AM
Replies:
2
RPM goes up during gear change
Views:
759
Posted By
merc380sel
my 85 380sel idle around 900rpm in D but shot up...
my 85 380sel idle around 900rpm in D but shot up to 1600rpm when I shift to N before settling down to around 900rpm again. This sudden surge of power always happened when I disengage.
Could it be a...
Forum:
Tech Help
05-12-2001, 05:21 AM
Replies:
1
Part Number 126 540 47 45
Views:
1,832
Posted By
merc380sel
Can anyone tell me specifically what is this part...
Can anyone tell me specifically what is this part for?
It it located in the fuse box of my 1985 380sel (euro).
Thank you.
Forum:
Tech Help
05-12-2001, 04:41 AM
Replies:
1
Over Voltage Protection Relay on W126
Views:
3,001
Posted By
merc380sel
Can anyone please tell me if my 1985 380sel has...
Can anyone please tell me if my 1985 380sel has one. I try to locate it in the fuse box but did not know which one. What is the part number of the OVP relay for the W126 380sel model?
Will changing...
Forum:
Tech Help
04-22-2001, 05:53 AM
Replies:
1
High RPM between gear change
Views:
664
Posted By
merc380sel
The engine of my 85 380sel surge from 900 to 1500...
The engine of my 85 380sel surge from 900 to 1500 rpm in between shfting and falls back to around 900 rpm again once engaged.
Is this normal for this car. Could it be a faulty idle speed actuator (...
Forum:
Tech Help
04-20-2001, 04:14 AM
Replies:
0
engine rev up between shifting
Views:
615
Posted By
merc380sel
I've replaced my Fuel Distributor (cost heaps!)....
I've replaced my Fuel Distributor (cost heaps!). Replaced 2 Injectors (6 still OK). Changed Fuel Filter. Replaced Idle Speed Actuator(idle speed controller).
My idle speed is now sitting at 900 RPM...
Forum:
Tech Help
03-27-2001, 04:32 AM
Replies:
3
W126 engine numbers
Views:
1,441
Posted By
merc380sel
I understand the 380 model has three different...
I understand the 380 model has three different engines fitted to it depending on where you live.
116. 961
116. 962
116. 963
Are they all the same or differ in something?
Which idle speed...
Forum:
Tech Help
03-20-2001, 12:24 AM
Replies:
5
Help Pls! high idle speed - constant 1300rpm
Views:
1,385
Posted By
merc380sel
I like to thank everyone for their very kind...
I like to thank everyone for their very kind feedback to my problem.
I just notice that my idle speed is sitting under 1000rpm just now! Used to be around 1300rpm yesterday until I replaced another...
Forum:
Tech Help
03-19-2001, 01:30 AM
Replies:
5
Help Pls! high idle speed - constant 1300rpm
Views:
1,385
Posted By
merc380sel
I've posted my high idle problem on my 380sel...
I've posted my high idle problem on my 380sel earlier.
I had replaced many parts as suggested by the members here.
I've replaced idle speed control unit 002 545 40 32. I've replaced idle speed...
Forum:
Tech Help
03-07-2001, 03:48 AM
Replies:
9
High Idle speed
Views:
3,045
Posted By
merc380sel
My 1985 380sel idle speed when gear is on N or P...
My 1985 380sel idle speed when gear is on N or P is around the 1400 rpm. It sometimes reach 2000rpm in between gear shift,
giving the car a hard jerk when gear is engaged.
My mechanic yesterday...
Showing results 1 to 23 of 23
Forum Jump
User Control Panel
Private Messages
Subscriptions
Who's Online
Search Forums
Forums Home
Mercedes-Benz Tech Information and Support
Tech Help
Diesel Discussion
Diesel Performance Tuning
Alternative Fuels
Vintage Mercedes Forum
Mercedes-Benz SL Discussion Forum
ML, GL, G-Wagen, R-Class, Unimog, Sprinter
Mercedes-Benz Performance Paddock
Mercedes-Benz Wheels & Tires
Car Audio and Multimedia
Detailing and Interior
Mercedes-Benz Classified Ads
Mercedes-Benz Cars For Sale
Mercedes-Benz Used Parts For Sale & Wanted
Pelican Parts Promos, Special Offers & New Products
Pelican Parts Mercedes-Benz Catalog
Do It Yourself Links & Resources
Restoration Projects & Long-Term Builds
Bodywork - Repair, Paint, Tools, Tips & Tricks
Mercedes Parts Reference Library
DIY Links by Parts Category
General Information
Tool Rental Program
Regional Forums
Southeast - US (AR,AL,FL,GA,KY,LA,MS,NC,SC,TN)
Pacific NorthWest -US (WA/ID/OR/UT/HI/AK)
Great Lakes - US (IL,IN,MI,MN,OH,WI)
Northeast - US (NY/NJ/CT/MA/ME/NH/RI/VT)
California / SouthWest - US (AZ/NV)
Middle Atlantic - US (DC,DE,MD,PA,VA,WV)
Tex-Mex (TX, OK, NM, Mexico)
Great Plains & Rocky Mountains - US (CO,IA,KS,MO,MT,ND,NE,SD,WY)
Video Forum
Featured Cars
Good MB Shops
Canada
International & Other
Events & Gatherings
General Discussions
Off-Topic Discussion
Site Feedback
All times are GMT -4. The time now is
02:44 AM
.
-- Normal ShopForum Style
---- Copy of Normal ShopForum Style
-- Pelican_Mobile
Contact Us
-
Mercedes-Benz Discussion Forum
-
Archive
-
Privacy Statement
-
Terms of Service
-
Top
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by
vBSEO
3.6.0
Copyright 2018 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -
DMCA Registered Agent Contact Page