Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Search Forums
Reload this Page Search Results
Register ShopForum Gallery FAQ Calendar Today's Posts Search

Page 1 of 3 1 23
Showing results 1 to 30 of 86
Search took 0.02 seconds. Search: Posts Made By: costanza
Forum: Mercedes-Benz Used Parts For Sale & Wanted 09-11-2008, 11:44 AM
Replies: 10
Views: 1,077
Posted By costanza
I still have lots of parts for sale :)

I still have lots of parts for sale :)
Forum: Mercedes-Benz Used Parts For Sale & Wanted 08-19-2008, 04:48 PM
Replies: 10
Views: 1,077
Posted By costanza
Sorry for not checking this thread sooner :( ...

Sorry for not checking this thread sooner :(

I'll contact each of you right now!
Forum: Mercedes-Benz Used Parts For Sale & Wanted 08-09-2008, 06:38 PM
Replies: 10
Views: 1,077
Posted By costanza
'91 & '92 190E parts for sale (might fit 300E/W124 as well)

I've got some parts FS. Make me an offer...

Set of 4 door opening trim pieces in gray - these are the fabric/rubber pieces that are about 7 ft long each and snap onto the sheetmetal lip around the...
Forum: Tech Help 06-07-2008, 10:37 AM
Replies: 0
Views: 747
Posted By costanza
brake booster help?

I think the brake vaccum booster in my '91 190E 2.6 is shot. Can someone tell me what models/years of other MB's have the same booster as my car? In other words, what about 2.3's or 2.5's? What about...
Forum: Mercedes-Benz Used Parts For Sale & Wanted 05-10-2008, 11:43 AM
Replies: 4
Views: 2,367
Posted By costanza
My car is a '91. I think the style of bumper...

My car is a '91. I think the style of bumper changed in either '89 or '90. Depending on price, I'll take any color in any reasonable condition. The bumper in the picture was blue and came from a...
Forum: Mercedes-Benz Used Parts For Sale & Wanted 05-09-2008, 10:40 PM
Replies: 4
Views: 2,367
Posted By costanza
Wanted: front bumper tow hook cover for 190E

It needs to match the style of this bumper...

http://i243.photobucket.com/albums/ff132/g-costanza/bump2.jpg
Forum: Tech Help 05-06-2008, 05:58 PM
Replies: 2
Views: 783
Posted By costanza
Thanks!

Thanks!
Forum: Tech Help 05-05-2008, 08:36 PM
Replies: 2
Views: 783
Posted By costanza
differential/driveshaft question

1991 190E 2.6, rear wheel drive
How can I get this to work... I need to be able to spin the driveshaft by spinning one of the rear wheels.
I know I've done this before, but now, when I spin a rear...
Forum: Tech Help 04-30-2008, 09:29 PM
Replies: 5
Views: 1,330
Posted By costanza
There's a DIY article on 190 revolution that...

There's a DIY article on 190 revolution that tells you how to re-stretch the old netting for $0 :)
Forum: Tech Help 04-29-2008, 09:40 PM
Replies: 0
Views: 717
Posted By costanza
weird handling issue

1991 190e 2.6 185K miles
Accelerating in a straight line on a flat road with new tires, somewhere around 50mph, the rear end feels squirmy, like it's on ice, just for a moment, and then goes away....
Forum: Tech Help 04-26-2008, 09:32 PM
Replies: 4
Views: 790
Posted By costanza
Anyone?

Anyone?
Forum: Tech Help 04-23-2008, 07:45 PM
Replies: 4
Views: 790
Posted By costanza
Does anyone know if the the seat bottom (padded...

Does anyone know if the the seat bottom (padded part - not movement mechanism) from a powered seat will fit the on the manual movment mechanism from an earlier 190E?

THANKS!
Forum: Tech Help 04-23-2008, 09:24 AM
Replies: 4
Views: 790
Posted By costanza
Thanks!

Thanks!
Forum: Tech Help 04-22-2008, 08:42 PM
Replies: 4
Views: 790
Posted By costanza
W201 seat bottoms

Are the front seat bottoms interchangeable with each other? In other words, can I switch the driver's seat bottom with the passenger seat bottom? I'm speaking of the padded bottom that bolts to the...
Forum: Tech Help 04-22-2008, 11:11 AM
Replies: 16
Views: 1,783
Posted By costanza
I thought the parts for this were at least...

I thought the parts for this were at least $40.00! Can you give me more info on the $20.00 power beeder?
Forum: Tech Help 04-21-2008, 05:45 PM
Replies: 16
Views: 1,783
Posted By costanza
I removed the master cylinder. Manually pumping...

I removed the master cylinder. Manually pumping it, fluid squirts out of the rear connection (front brakes?), but the fluid barely comes out of the front connection (rear brakes?). So I guess this...
Forum: Tech Help 04-20-2008, 11:47 PM
Replies: 16
Views: 1,783
Posted By costanza
I'll check it again, but I filled to the very top...

I'll check it again, but I filled to the very top of the spout as I bled.
Forum: Tech Help 04-20-2008, 08:26 PM
Replies: 16
Views: 1,783
Posted By costanza
As far as I see the reservoir is full all around.

As far as I see the reservoir is full all around.
Forum: Tech Help 04-20-2008, 01:37 PM
Replies: 16
Views: 1,783
Posted By costanza
Master cylinder or vacuum booster, or both!

While bleeding brakes, the pump monkey said the pedal went straight to the floor without me opening bleeder valve. I opened up the bleeder valve while pedal was down and fluid, which had been...
Forum: Tech Help 04-14-2008, 08:09 PM
Replies: 1
Views: 922
Posted By costanza
Need Mercedes ball joint expert advice

Is there a factory spec of how much force a ball joint must be held into the front lower control arm of a '91 190E? If no spec, how does the factory say that the fitting is correct/sufficient?
Other...
Forum: Tech Help 04-12-2008, 11:51 PM
Replies: 7
Views: 3,342
Posted By costanza
http://i243.photobucket.com/albums/ff132/g-costanz...

http://i243.photobucket.com/albums/ff132/g-costanza/bush.jpg
Forum: Tech Help 04-12-2008, 07:55 PM
Replies: 7
Views: 3,342
Posted By costanza
This section of the Haynes manual directly...

This section of the Haynes manual directly contradicts MBDOC :(
Who to believe? I need to know.

http://i243.photobucket.com/albums/ff132/g-costanza/bushing.jpg
Forum: Tech Help 04-11-2008, 12:47 AM
Replies: 3
Views: 832
Posted By costanza
If you lightly tapped on the top of the ball...

If you lightly tapped on the top of the ball joint and it fell out, would that concern you?
Forum: Tech Help 04-10-2008, 11:49 PM
Replies: 3
Views: 832
Posted By costanza
ball joint pressure?

I just had some ball joints installed in the front lower control arms of my '91 190E. The arms aren't installed in the car yet, but at least one ball joint will fall out if you tap on it with very...
Forum: Tech Help 04-10-2008, 10:48 AM
Replies: 7
Views: 3,342
Posted By costanza
Now I'm confused. The Haynes manual says on the...

Now I'm confused. The Haynes manual says on the front bushings the flats need to be facing up.
BTW, other than the "nubs", all 8 bushing halfs appear to be identical.
Forum: Tech Help 04-09-2008, 09:36 PM
Replies: 7
Views: 3,342
Posted By costanza
W201 front lower control arm bushing question

I replaced the front lower control arm bushings on my '91 190E 2.6. On each arm, one bushing was rubber while the other was metal and rubber. The replacements are all rubber. Of the sets I got, all...
Forum: Tech Help 04-03-2008, 02:37 PM
Replies: 1
Views: 1,300
Posted By costanza
1991 190E W201 front wheel bearings

How do you change them? How do you re-pack them? I've searched, but can't find the instructions.

Thanks!
Forum: Tech Help 04-03-2008, 12:11 AM
Replies: 9
Views: 1,556
Posted By costanza
Sure :) I ordered a coil spring compressor...

Sure :)
I ordered a coil spring compressor today to refurbish the front lower control arms. I've already received the front lower control arm bushings and ball joints (about $100 total from...
Forum: Tech Help 04-01-2008, 11:30 PM
Replies: 9
Views: 1,556
Posted By costanza
Not really. I was stripping my wrecked '92 to the...

Not really. I was stripping my wrecked '92 to the bone. I sold the shell of the car to the salvage guy today for $50.
Forum: Tech Help 04-01-2008, 09:03 PM
Replies: 3
Views: 749
Posted By costanza
Thanks MTI. There is an airbag on ebay that has...

Thanks MTI. There is an airbag on ebay that has the number 140 460 12 98. The front looks like mine, but the back is totally different!
My '92 190E airbag looks identical to this one....
Showing results 1 to 30 of 86
Page 1 of 3 1 23

 
Forum Jump


All times are GMT -4. The time now is 04:28 PM.

Contact Us - Mercedes-Benz Discussion Forum - Archive - Privacy Statement - Terms of Service - Top

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page