Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Search Forums
Reload this Page Search Results
Register ShopForum Gallery FAQ Calendar Today's Posts Search

Page 1 of 12 1 2311 Last »
Showing results 1 to 30 of 338
Search took 0.04 seconds. Search: Posts Made By: petecooke
Forum: Diesel Discussion 02-21-2024, 08:10 AM
Replies: 3
Views: 212
Posted By petecooke
Thanks imgolden. I'll pick some up today and post...

Thanks imgolden. I'll pick some up today and post a reply to confirm later today.

pete
Forum: Diesel Discussion 02-20-2024, 09:34 PM
Replies: 3
Views: 212
Posted By petecooke
1983 rear fuel line ID diameter near tank ?

I have a leak near my tank and I assume it's one of the 2 short fuel lines not the one that unscrews from the tank screen.

Not sure if the hose closer to the passenger side is the return or not....
Forum: Diesel Discussion 01-04-2023, 08:19 AM
Replies: 4
Views: 444
Posted By petecooke
Not yet. I should have this done next the next...

Not yet. I should have this done next the next couple of week. I will post photos of the job when I complete it.

pete
Forum: Diesel Discussion 12-28-2022, 09:10 AM
Replies: 4
Views: 444
Posted By petecooke
I was able to find this site that lists all the...

I was able to find this site that lists all the parts.

https://nemigaparts.com/cat_spares/epc/mercedes/
https://nemigaparts.com/cat_spares/epc/mercedes/1/fg/123123/68k/42/120/...
Forum: Diesel Discussion 12-27-2022, 09:48 AM
Replies: 4
Views: 444
Posted By petecooke
1983 240d Parking brake cable broke near pedal

I pushed my parking brake down and the end of cable broke off. When I pull the brake release the pedal doesn't retract. I've replaced brake cables that go to the rear wheels but never the cable that...
Forum: Diesel Discussion 10-28-2022, 08:13 AM
Replies: 12
Views: 1,179
Posted By petecooke
Will do. Thanks Pete

Will do.

Thanks

Pete
Forum: Diesel Discussion 10-27-2022, 04:56 PM
Replies: 12
Views: 1,179
Posted By petecooke
I installed the bushings today. This is the part...

I installed the bushings today. This is the part you need.

Mercedes-Benz Gear Shift Bushing - Output Shaft to Shift Rod Gear Range Selector Lever Febi Bilstein 19953
...
Forum: Diesel Discussion 10-26-2022, 08:30 PM
Replies: 12
Views: 1,179
Posted By petecooke
Parts just came today. I'll install tomorrow. I...

Parts just came today. I'll install tomorrow. I can put my car in reverse without lifting the stick. I'm hoping this fixes that problem or maybe makes it a little harder to put in reverse by...
Forum: Diesel Discussion 10-22-2022, 05:13 PM
Replies: 12
Views: 1,179
Posted By petecooke
It looks like I need these. I actually just need...

It looks like I need these. I actually just need the bushings but not sure if you can buy they separately.
...
Forum: Diesel Discussion 10-21-2022, 10:26 AM
Replies: 12
Views: 1,179
Posted By petecooke
1983 240d 300k+ manual transmission bushings

I need transmission bushings under my car farthest from the engine. The black bushings near the engine seem fine. The bushing on the other end do not exist. It's just metal on metal.

I have a...
Forum: Diesel Discussion 10-19-2022, 03:43 PM
Replies: 7
Views: 852
Posted By petecooke
upod, Thanks for your reply and concerns. ...

upod,

Thanks for your reply and concerns.

I should have stated I attempted to use a wheel puller but that was completely useless even after tightening it to almost stripping the thread and...
Forum: Diesel Discussion 10-18-2022, 11:18 PM
Replies: 7
Views: 852
Posted By petecooke
I was hitting it with a 12 lb sledgehammer and it...

I was hitting it with a 12 lb sledgehammer and it was barely moving. That's when I decided to add Heat.

I reinstalled with Anti-Seize and grease.
Forum: Diesel Discussion 10-18-2022, 05:08 PM
Replies: 7
Views: 852
Posted By petecooke
Ok, I got it out. I hit with acetylene and my...

Ok, I got it out. I hit with acetylene and my torbo torch. Then pounded with a 17mm impact inside the hub and a 19mm held with vice grips and hit with baby sledge.

No replied on this message but I...
Forum: Diesel Discussion 10-18-2022, 04:15 PM
Replies: 7
Views: 852
Posted By petecooke
It's an after market axle and it has allen bolts...

It's an after market axle and it has allen bolts near the differential. I took those off and dropped the axle but it's still stuck in the hub. Just hit it with pb blaster again. Going to pound on it...
Forum: Diesel Discussion 10-18-2022, 03:38 PM
Replies: 7
Views: 852
Posted By petecooke
Rear passenger side axel doesn't want to come out of the hub

1983 240d 300k.

The Drivers side came out no problem. The the passenger side doesn't seem to mover much. I've hit the axel with a baby sledge after putting a a pipe in the hub and nothing. I feel...
Forum: Diesel Discussion 02-09-2022, 09:36 PM
Replies: 6
Views: 508
Posted By petecooke
That could be the problem. Is ATE or Bendix...

That could be the problem. Is ATE or Bendix stamped anywhere on the caliper?
I'll take a look at the caliper and see if I can find any info.

Thanks,

pete
Forum: Diesel Discussion 02-09-2022, 04:45 PM
Replies: 6
Views: 508
Posted By petecooke
w123 brake pins length

I have a 1983 240d and the paseenger front brake caliper was leaking fluid so I swapped it out today with a spare I pulled off another w123. The spare didn't have the pins that slide through the pads...
Forum: Diesel Discussion 03-02-2021, 12:48 PM
Replies: 2
Views: 392
Posted By petecooke
water behind drivers seat and icicle under car

Is this a sunroof leak issues?

Thanks,

Petge
Forum: Diesel Discussion 02-10-2020, 10:58 PM
Replies: 5
Views: 723
Posted By petecooke
Thanks guys. I'm going to AutoZone tomorrow and...

Thanks guys. I'm going to AutoZone tomorrow and getting a vacuum pump loaner tool.

Pete
Forum: Diesel Discussion 02-10-2020, 05:37 PM
Replies: 5
Views: 723
Posted By petecooke
W123 1982 240d

I recently decided to flush my brake fluid in clutch fluid Since it looked like filthy.

I used a turkey baster and sucked all the fluid out of the Reservoir and remove the reservoir and washed it...
Forum: Diesel Discussion 01-02-2020, 07:54 AM
Replies: 2
Views: 1,231
Posted By petecooke
It actually worked well for about 2 hours but...

It actually worked well for about 2 hours but then I pushed the shifter a little to hard into reverse and the switch popped out of it's plastic holder/bracket.

I ended up carefully taking the...
Forum: Diesel Discussion 01-01-2020, 12:47 PM
Replies: 2
Views: 1,231
Posted By petecooke
FYI - 240d reverse backup light switch fix

My 1982 240d reverse lights stopped working.
I pulled the center console and used a small piece and taped it on the plate on the shifter that pushing in the rod on the reverse light switch.
...
Forum: Diesel Discussion 12-31-2019, 09:32 PM
Replies: 12
Views: 2,764
Posted By petecooke
I just found this thread in a search and wanted...

I just found this thread in a search and wanted to post the part number for the 30mm 12 point nut.

Febi Auto Trans Output Shaft Flange Nut; Rear Transmission Flange/Driveshaft Coupling
P/N:...
Forum: Diesel Discussion 12-31-2019, 06:27 PM
Replies: 42
Views: 2,037
Posted By petecooke
Sugar Bear, thanks. I did notice that you could...

Sugar Bear, thanks. I did notice that you could put the friction plate in the wrong way. I think I have it right since all the gears a shifting smoothly.

pete
Forum: Diesel Discussion 12-31-2019, 06:25 PM
Replies: 42
Views: 2,037
Posted By petecooke
123boy, thanks for the reply. I did notice lots...

123boy, thanks for the reply. I did notice lots of wear on the push rod from my slave cylinder and I'm sure that was do because of the hole in the fork. My slave cylinder is fairly new and I don't...
Forum: Diesel Discussion 12-31-2019, 06:19 PM
Replies: 42
Views: 2,037
Posted By petecooke
Frank, I'm a little unclear of what you're...

Frank,

I'm a little unclear of what you're saying. I've attached pictures of the parts I installed.

I have everything back together and the clutch feels great. Do the parts in the picture look...
Forum: Diesel Discussion 12-31-2019, 06:59 AM
Replies: 42
Views: 2,037
Posted By petecooke
Thanks rwd4evr. I remove all the grease and put a...

Thanks rwd4evr. I remove all the grease and put a thin coating of the Sachs spline grease.

pete
Forum: Diesel Discussion 12-30-2019, 10:16 PM
Replies: 42
Views: 2,037
Posted By petecooke
Thanks for the info t walgamuth. I know what...

Thanks for the info t walgamuth.

I know what you mean about the wear on a brake rotor and there is no lip, grooves or uneven wear on the flywheel.

I could probably still use the friction disc...
Forum: Diesel Discussion 12-30-2019, 10:04 PM
Replies: 42
Views: 2,037
Posted By petecooke
Thanks for the info Nate. Maybe I'll skip...

Thanks for the info Nate.

Maybe I'll skip the machine shop. The flywheel feels very smooth and even. I could see turning the flywheel if the friction plate was completely worn and the rivets were...
Forum: Diesel Discussion 12-30-2019, 06:12 PM
Replies: 42
Views: 2,037
Posted By petecooke
last 3 pics

In the first picture, there looks like a cover of the clutch pilot bearing. Is that part of the bearing. I would going to use the bread trick to remove the bearing.

I'm going to bring the flywheel...
Showing results 1 to 30 of 338
Page 1 of 12 1 2311 Last »

 
Forum Jump


All times are GMT -4. The time now is 12:30 PM.

Contact Us - Mercedes-Benz Discussion Forum - Archive - Privacy Statement - Terms of Service - Top

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page