Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Search Forums
Reload this Page Search Results
Register ShopForum Gallery FAQ Calendar Today's Posts Search

Page 1 of 5 1 23 Last »
Showing results 1 to 30 of 121
Search took 0.02 seconds. Search: Posts Made By: meek
Forum: Mercedes-Benz SL Discussion Forum 03-26-2016, 11:40 AM
Replies: 2
Views: 955
Posted By meek
R129 buyer q

Hi. I'm interested in getting a r129. My thoughts are a V8 as the V12 seems too costly to maintain and the 6 is perhaps a little underpowered. I saw praise for the 96+ 5 sp auto, but also saw some...
Forum: Diesel Discussion 01-17-2015, 06:40 PM
Replies: 4
Views: 745
Posted By meek
Car was blowing oil straight out of the area....

Car was blowing oil straight out of the area. Took off crossover pipe and noticed that a part of the o-ring was completely destroyed. Then I thought it wasn't like this before... then I realized it...
Forum: Diesel Discussion 01-13-2015, 03:58 PM
Replies: 4
Views: 745
Posted By meek
Part question

Can someone tell me if W0133-1635833 is the part number for the large o-ring that is on the turbo side of the crossover pipe (other side of pipie goes to intake manifold and has a flat gasket)? And...
Forum: Diesel Discussion 05-05-2014, 05:13 PM
Replies: 8
Views: 2,289
Posted By meek
Rented the fork. Outer one popped out, but inner...

Rented the fork. Outer one popped out, but inner has a knuckle from some other part that interferes with the fork sliding through enough to remove it, it gets almost there (about halfway through the...
Forum: Diesel Discussion 05-05-2014, 12:52 PM
Replies: 8
Views: 2,289
Posted By meek
Tie rods Change (Help needed)

Hi All. I am trying to replace the tie rods on the 124. How do you remove them? I took the nuts off of the inner and outer, but isn't budging. Smack with hammer? Do I need to loosen anything along...
Forum: Diesel Discussion 03-24-2014, 10:16 AM
Replies: 1
Views: 471
Posted By meek
All 4 tires outer edges worn heavily

Hi All. Just visited my father and saw that all 4 of the 1990 300D 2.5T's new (last year) tires were worn bald on the outer edges. This would normally be attributed to alignment, correct? Would it be...
Forum: Mercedes-Benz Performance Paddock 09-29-2013, 05:34 PM
Replies: 50
Views: 16,580
Posted By meek
Pics?

Pics?
Forum: Diesel Discussion 07-06-2012, 06:28 PM
Replies: 5
Views: 763
Posted By meek
Done. Wiggle ;) with a large screwdriver...

Done.

Wiggle ;) with a large screwdriver for 20 min from various sides using leverage...:eek: and voila...:cool:
Forum: Diesel Discussion 07-06-2012, 04:52 PM
Replies: 5
Views: 763
Posted By meek
Bump as still cant remove...:(

Bump as still cant remove...:(
Forum: Diesel Discussion 07-06-2012, 04:51 PM
Replies: 2
Views: 1,882
Posted By meek
Thanks.

Thanks.
Forum: Diesel Discussion 07-06-2012, 12:52 PM
Replies: 2
Views: 1,882
Posted By meek
Intake Manifold Removal Q 1990 300D 2.5T

Hi. Just cleaned crossover pipe and see that the intake manifold has a lot of crap in it. Does anyone have a tutorial on intake manifold removal for a 1990 300D 2.5T (602?)? I see all the manifold...
Forum: Diesel Discussion 06-05-2012, 10:22 AM
Replies: 5
Views: 763
Posted By meek
Sorry. 1990 300D 2.5T

Sorry.

1990 300D 2.5T
Forum: Diesel Discussion 06-01-2012, 09:07 AM
Replies: 5
Views: 763
Posted By meek
Bump as I still need assistance. Thank you.

Bump as I still need assistance. Thank you.
Forum: Diesel Discussion 05-30-2012, 10:18 AM
Replies: 31
Views: 4,266
Posted By meek
Was a carb engine. Back then they were what they...

Was a carb engine. Back then they were what they designated on the 123s.
Gas motors consisted of 200, 230, 230E, 250, 280, 280E..only the 200 was available in the later years in carb form if memory...
Forum: Diesel Discussion 05-29-2012, 04:50 PM
Replies: 5
Views: 763
Posted By meek
How to remove idle servo / solenoid connector

I need to remove the idle servo / solenoid connector to change the fuel shut off valve. I twisted the lower section counter clockwise the full 1/4 turn. Top part refuses to come off (I'm assuming I...
Forum: Diesel Discussion 11-15-2011, 08:50 AM
Replies: 4
Views: 670
Posted By meek
300D 2.5T 'turbo question'

1990 300D 2.5T probably has a bad turbo (blowing bluish smoke under load). Couple of questions for the audience:

1. How much is a rebuild? Who would you use?

2. Other alternative turbos? Pros...
Forum: Diesel Discussion 11-02-2011, 07:57 PM
Replies: 8
Views: 867
Posted By meek
Cars looked crazy rough. One supposedly had...

Cars looked crazy rough. One supposedly had everything working sans sunroof. Interiors: dash, panels, knobs, seating surfaces were like post-Armageddon. Low rust. Relatively low miles 170-240....
Forum: Diesel Discussion 11-01-2011, 10:48 AM
Replies: 8
Views: 867
Posted By meek
Thanks

Thanks
Forum: Diesel Discussion 11-01-2011, 08:29 AM
Replies: 8
Views: 867
Posted By meek
300SDs

300SDs
Forum: Diesel Discussion 10-31-2011, 11:38 PM
Replies: 8
Views: 867
Posted By meek
Looking at 2 126s tomorrow...help

Looking at 2 w126s tomorrow. Anything in particular to look out for? One isn't running. Thanks.
Forum: Diesel Discussion 10-22-2011, 05:40 PM
Replies: 2
Views: 712
Posted By meek
Buyer's guide?

In the market for a couple of W123 diesels. Thinking a TD and a CD. What am I to look out for? What are easy fixes vs $$$$$ fixes? Thanks.

FWIW usually I am a "Search King", just don't have the...
Forum: Diesel Discussion 07-12-2011, 10:11 AM
Replies: 12
Views: 775
Posted By meek
Thanks

Thanks
Forum: Diesel Discussion 07-12-2011, 08:40 AM
Replies: 12
Views: 775
Posted By meek
Brakes - occasionally not there

The 90 300D (250D Turbo) has begun to develop a brake issue. 99% of the time the brakes work fine, the other 1% you hit the brake pedal and it starts to go to the floor and the car does not slow...
Forum: Tech Help 07-11-2011, 09:16 AM
Replies: 5
Views: 877
Posted By meek
Brakes - occasionally not there

The 90 300D (250D Turbo) has begun to develop a brake issue. 99% of the time the brakes work fine, the other 1% you hit the brake pedal and it starts to go to the floor and the car does not slow...
Forum: Mercedes-Benz Cars For Sale 05-31-2010, 10:52 PM
Replies: 18
Views: 2,386
Posted By meek
300te

PMed
Forum: Tech Help 08-13-2009, 09:22 AM
Replies: 0
Views: 653
Posted By meek
Considering a C240 4matic...issues?

I am thinking about picking up a 2003-4 C240 4Matic, since I am moving to the mountains. Are there any known issues with this model? Thanks for the advice. :)
Forum: Diesel Discussion 05-23-2008, 02:35 PM
Replies: 8
Views: 1,194
Posted By meek
Thanks. :D

Thanks. :D
Forum: Diesel Discussion 05-23-2008, 02:27 PM
Replies: 8
Views: 1,194
Posted By meek
Lastly, preference on engine oil?

Lastly, preference on engine oil?
Forum: Diesel Discussion 05-23-2008, 02:24 PM
Replies: 8
Views: 1,194
Posted By meek
Are all of the fuel filters e.g Mann, Mahle,...

Are all of the fuel filters e.g Mann, Mahle, Bosch, etc equal?
Forum: Diesel Discussion 05-23-2008, 02:16 PM
Replies: 8
Views: 1,194
Posted By meek
Which rear diff and tranny fluid is recommended?...

Which rear diff and tranny fluid is recommended? My 2.3 16v loved Redline, but I can't recall which Redline products...:rolleyes:
Showing results 1 to 30 of 121
Page 1 of 5 1 23 Last »

 
Forum Jump


All times are GMT -4. The time now is 06:44 PM.

Contact Us - Mercedes-Benz Discussion Forum - Archive - Privacy Statement - Terms of Service - Top

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page