Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Search Forums
Reload this Page Search Results
Register ShopForum Gallery FAQ Calendar Today's Posts Search

Page 1 of 14 1 2311 Last »
Showing results 1 to 30 of 392
Search took 0.06 seconds. Search: Posts Made By: franklyspeaking
Forum: Diesel Discussion 03-24-2024, 12:49 PM
Replies: 3
Views: 160
Posted By franklyspeaking
I have trailer at home, but need to get home? ...

I have trailer at home, but need to get home? Possibly could rent a car get home, then come back and get it with the trailer?

Thanks. Probably need to do this.
Forum: Diesel Discussion 03-24-2024, 12:13 PM
Replies: 3
Views: 160
Posted By franklyspeaking
This is an 2007 E320 OM642.

This is an 2007 E320 OM642.
Forum: Diesel Discussion 03-24-2024, 12:08 PM
Replies: 3
Views: 160
Posted By franklyspeaking
Failed Turbo - 350 Moles from Home

I am in the midst of a 500 mile trip from Hilton Head, SC to North Alabama. My Turbo has failed, and I have little power. Worse is I think the turbo oil seals are shot and I using a huge amount of...
Forum: Diesel Discussion 03-12-2024, 08:27 PM
Replies: 5
Views: 275
Posted By franklyspeaking
Finished the job this afternoon and took a test...

Finished the job this afternoon and took a test drive. No Turbo Boost?!! I checked it and it is turning, but no boost. I checked the connector from the two wire at back of the turbo and the one in...
Forum: Diesel Discussion 03-06-2024, 11:17 PM
Replies: 5
Views: 275
Posted By franklyspeaking
Question Swirl Motor Delete/Oil Cooler Seal Saga

I ordered a 4.7k resistor, but I could not discern where it must be plugged in. The swirl motor has a 4 pin plug with 3 wires (Brown, Red/Green, Gray). My guess would be Brown and Red/Green? ...
Forum: Diesel Discussion 02-24-2024, 10:47 PM
Replies: 7
Views: 369
Posted By franklyspeaking
Just as a follow-up, I have solved the problem. ...

Just as a follow-up, I have solved the problem. I changed the MAF’s with known good Bosch ones, and the car now runs pretty smooth. There is some minor stuttering, but 99% gone. There may still be...
Forum: Diesel Discussion 02-20-2024, 12:58 PM
Replies: 7
Views: 369
Posted By franklyspeaking
Don’t know how to do this. Can it be done with...

Don’t know how to do this. Can it be done with my icarsoft 980? I have viewed the data readings and the sensors look reasonably close. I have new filters and I am going to change them. Also, have...
Forum: Diesel Discussion 02-18-2024, 10:38 PM
Replies: 7
Views: 369
Posted By franklyspeaking
I was able to get rid of 2633-001 code by rapidly...

I was able to get rid of 2633-001 code by rapidly accelerating up to 80 mph with the engine warmed up. I found that when you do this the car will then run smooth with no jerking at any speed or load...
Forum: Diesel Discussion 02-12-2024, 09:45 PM
Replies: 7
Views: 369
Posted By franklyspeaking
E320 Issues

I bought this car 7/22 with 151K, knowing very little about it with the exception that it had a very long range and a diesel engine. I wanted it to pull a teardrop trailer to Alaska and back from...
Forum: Mercedes-Benz SL Discussion Forum 09-07-2023, 11:01 AM
Replies: 2
Views: 1,144
Posted By franklyspeaking
Have not used it, but if your vehicle’s jack...

Have not used it, but if your vehicle’s jack holes are sound this should be a better way utilize a floor jack to jack up the car. The leverage point may be little further out, but as a percentage of...
Forum: Mercedes-Benz SL Discussion Forum 09-03-2023, 02:53 PM
Replies: 1
Views: 974
Posted By franklyspeaking
560sl Starting Issues

I have a 560sl and began to have some drivability issues a while back. It started easily and idled well, but when you pressed down hard on the accelerator it bogged down. If you pressed it lightly...
Forum: Vintage Mercedes Forum 12-11-2022, 12:44 AM
Replies: 2
Views: 921
Posted By franklyspeaking
Thanks for the reading material. I made some...

Thanks for the reading material. I made some slight progress today by getting the switch installed and got the cable installed on the run/stop lever. Adjustment is still needed as the gorilla knob...
Forum: Vintage Mercedes Forum 12-09-2022, 09:49 PM
Replies: 2
Views: 921
Posted By franklyspeaking
W115 240D Engine Service Manual

Recently bought a badly neglected non-running 1974 240D. The starter/glow plug switch was dismantled and non functional, and so I can’t really try to start it until I can get it reinstalled and...
Forum: Mercedes-Benz SL Discussion Forum 07-20-2019, 12:20 AM
Replies: 5
Views: 3,056
Posted By franklyspeaking
Looks as though the colors are not exact mercedes...

Looks as though the colors are not exact mercedes sl colors. Black might match okay, but I don't see palomino and their beige doesn't look the same.
Forum: Mercedes-Benz Cars For Sale 03-06-2018, 10:30 PM
Replies: 5
Views: 1,605
Posted By franklyspeaking
Thumbs up So has the blue dash been replaced with a black...

So has the blue dash been replaced with a black one? Never seen blue interior and black dash.
Forum: Diesel Discussion 01-27-2018, 09:55 PM
Replies: 9
Views: 781
Posted By franklyspeaking
Have you adjusted the valves lately?

Have you adjusted the valves lately?
Forum: Diesel Discussion 01-06-2018, 11:15 PM
Replies: 32
Views: 2,320
Posted By franklyspeaking
I had a timing chain break due to tensioner...

I had a timing chain break due to tensioner failure. The chain doubled up on the crank sprocket and put a hole in the oil pan. Had to pull the engine to remove and repair the oil pan.
Forum: Tech Help 10-22-2015, 08:41 AM
Replies: 2
Views: 2,510
Posted By franklyspeaking
Smile Thanks for the info. The vacuum line hooks...

Thanks for the info. The vacuum line hooks underneath the intake manifold and is pretty difficult to access. For now I plugged the hole and teed the vacuum line into the EGR Intake Pressure switch...
Forum: Tech Help 10-20-2015, 02:07 PM
Replies: 2
Views: 2,510
Posted By franklyspeaking
Loose Vacuum Line 1998 C280 (M112 V6)

I have found a loose vacuum line that is related to the unknown components below. Looking at front of the engine on the drivers side: The left ? is the loose vacuum line, the center ? is an unknown...
Forum: Diesel Discussion 08-07-2015, 10:57 AM
Replies: 16
Views: 1,964
Posted By franklyspeaking
I had an 82 for 15 years and so I know how...

I had an 82 for 15 years and so I know how difficult it is to keep them clean, especially the engine bay. It looks great....in remarkably good condition. They just don't do paint like they did on...
Forum: Tech Help 06-16-2015, 01:08 PM
Replies: 6
Views: 843
Posted By franklyspeaking
I have a 1998 C280 and get about 24 mpg in my...

I have a 1998 C280 and get about 24 mpg in my daily commute to work. 10 mile rural/city drive. Although I have yet to take it on a road trip, I have noticed that a couple of longer drives has seen...
Forum: Tech Help 05-13-2015, 04:43 PM
Replies: 62
Views: 33,698
Posted By franklyspeaking
Not sure what kind of a car you and Matt have,...

Not sure what kind of a car you and Matt have, but I have a 1998 C280 and mine is in the trunk and plugged into a cable (not a relay rack). It has 5 or 6 pins. It is near the back on the right hand...
Forum: Diesel Discussion 03-31-2015, 03:30 PM
Replies: 8
Views: 783
Posted By franklyspeaking
If it is leaking soapy water will show the leak.;)

If it is leaking soapy water will show the leak.;)
Forum: Tech Help 03-02-2015, 03:17 PM
Replies: 8
Views: 967
Posted By franklyspeaking
The ones at the local auto parts places (advance,...

The ones at the local auto parts places (advance, oreilley, autozone) require you to purchase and then will refund the full amount when you return it.
Forum: Tech Help 02-13-2015, 11:13 AM
Replies: 3
Views: 829
Posted By franklyspeaking
So how would the dealer do this? Do they plug...

So how would the dealer do this? Do they plug into another diagnostic port other than the OBDII port? I guess I could find out by taking to the dealer, but it is 30 miles away, and I would likely...
Forum: Tech Help 02-12-2015, 05:02 PM
Replies: 3
Views: 829
Posted By franklyspeaking
SRS Light

I have two issues that I have been trying to cure on my '98 C280. The cruise control switch is broken and the steering wheel squeaks in cold weather. In order to repair both, the steering wheel...
Forum: Tech Help 02-12-2015, 04:32 PM
Replies: 12
Views: 1,422
Posted By franklyspeaking
If it is vibrating at 5-8 mph, perhaps you could...

If it is vibrating at 5-8 mph, perhaps you could put the rear securely on jack stands and view what is going on? Of course, not suggesting you do anything unsafe.
Forum: Tech Help 02-12-2015, 08:41 AM
Replies: 12
Views: 1,422
Posted By franklyspeaking
Sounds to me like the motor mounts are loose in...

Sounds to me like the motor mounts are loose in front and the sub-frame loose in back, and the only thing keeping the drive-train in tact is the center drive line support and possibly the...
Forum: Diesel Discussion 02-10-2015, 12:02 PM
Replies: 29
Views: 1,878
Posted By franklyspeaking
For what it's worth, Chattanooga doesn't get a...

For what it's worth, Chattanooga doesn't get a lot of snow, and I don't think they use salt on the roads (could be wrong - they have a lot of hills/mountains). I had a 1982 240D, which always lived...
Forum: Tech Help 02-03-2015, 04:32 PM
Replies: 11
Views: 1,586
Posted By franklyspeaking
Bad MAF caused my C280 to surge at idle. Ran...

Bad MAF caused my C280 to surge at idle. Ran good down the road. I tried to clean it, but no help until it was replaced.
Showing results 1 to 30 of 392
Page 1 of 14 1 2311 Last »

 
Forum Jump


All times are GMT -4. The time now is 04:08 AM.

Contact Us - Mercedes-Benz Discussion Forum - Archive - Privacy Statement - Terms of Service - Top

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page