Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Search Forums

Showing results 1 to 30 of 500
Search took 0.12 seconds.
Search: Posts Made By: david s poole
Forum: Tech Help 05-19-2011, 12:05 PM
Replies: 15
Views: 7,696
Posted By david s poole
based on your numbers i strongly suggest that you...

based on your numbers i strongly suggest that you get a cat replacement.here in texas that can be done for less than 300 installed and will make a huge diff to your readings and you won't have to...
Forum: Tech Help 05-13-2011, 02:19 PM
Replies: 4
Views: 1,211
Posted By david s poole
the easy way to go with that is to find a good...

the easy way to go with that is to find a good 560 engine and fit it with the intake off the 500.[suggest rebuilding the intake while off]
Forum: Tech Help 05-13-2011, 11:32 AM
Replies: 13
Views: 2,084
Posted By david s poole
dealership will have those parts and are only...

dealership will have those parts and are only moderately expensive.but you will get oem clutch plates which can be an issue.
Forum: Tech Help 05-13-2011, 11:27 AM
Replies: 43
Views: 5,126
Posted By david s poole
a trick i often use is to pump up the rear tires...

a trick i often use is to pump up the rear tires to about 45psi for the test.when car sits on dyno there are two bags created with two dyno rollers and this adds to the drag.higher tire pressures...
Forum: Tech Help 01-28-2011, 06:08 PM
Replies: 3
Views: 697
Posted By david s poole
can't believe that the guy in autoparts store...

can't believe that the guy in autoparts store after you told story didn't undo two screws and check the brushes.
Forum: Tech Help 01-28-2011, 06:04 PM
Replies: 10
Views: 1,001
Posted By david s poole
take out both front o2 sensors and drive it.if...

take out both front o2 sensors and drive it.if plugged cat that will relieve pressure.
Forum: Tech Help 01-28-2011, 05:29 PM
Replies: 12
Views: 1,096
Posted By david s poole
the only thing i can think of is the kickdown...

the only thing i can think of is the kickdown solenoid that it might be sticking on causing the holding of lower gear.
Forum: Tech Help 12-18-2010, 10:34 AM
Replies: 2
Views: 1,093
Posted By david s poole
look very carefully at the fuse list.i ran into...

look very carefully at the fuse list.i ran into this about 2 mths ago and had to replace a fuse before communicating with obd2.
Forum: Tech Help 12-07-2010, 03:53 PM
Replies: 6
Views: 2,029
Posted By david s poole
i think that what you have left now with 420 is a...

i think that what you have left now with 420 is a worn out idle valve.replacing valve on my 420 cured the high idle.
Forum: Tech Help 11-30-2010, 11:55 AM
Replies: 11
Views: 1,679
Posted By david s poole
replace those two tires,been there many times.

replace those two tires,been there many times.
Forum: Tech Help 11-30-2010, 11:49 AM
Replies: 10
Views: 1,901
Posted By david s poole
the codes you pulled almost always imply that the...

the codes you pulled almost always imply that the mass air needs replacing along with resetting the adaptions.the assenmacher will do this as it's what i use.
Forum: Tech Help 11-18-2010, 10:16 AM
Replies: 9
Views: 1,699
Posted By david s poole
that line is not even vacuum it is...

that line is not even vacuum it is depression[maybe 1/2 inch vacuum] with engine running.it is there as a safety in case the diaphram ruptures,which i have never seen happen.
Forum: Tech Help 11-13-2010, 11:21 AM
Replies: 12
Views: 895
Posted By david s poole
replace all four sway bar bushings,it will make a...

replace all four sway bar bushings,it will make a very nice difference and cheap to do.
Forum: Tech Help 11-09-2010, 12:00 PM
Replies: 7
Views: 1,983
Posted By david s poole
basically when you pull the ovp relay you kill...

basically when you pull the ovp relay you kill the power to the fuel injection computer.the fact that it won't run at this point usually means that you don't have enough fuel dialed in at the...
Forum: Tech Help 11-05-2010, 10:35 AM
Replies: 8
Views: 1,460
Posted By david s poole
ok now your on the list----ha ha.

ok now your on the list----ha ha.
Forum: Tech Help 11-05-2010, 10:32 AM
Replies: 5
Views: 920
Posted By david s poole
i think the reason that that balancer is that...

i think the reason that that balancer is that worn is that a very worn flex disc was being used while the driver explored the upper limits of the rev range.
Forum: Tech Help 11-04-2010, 12:18 PM
Replies: 2
Views: 736
Posted By david s poole
are you sure that you cranked the steering lock...

are you sure that you cranked the steering lock to lock a couple times? if so you will need to replace the brake light switch[oem only].
Forum: Tech Help 10-28-2010, 12:13 PM
Replies: 3
Views: 853
Posted By david s poole
ditto

ditto
Forum: Tech Help 10-28-2010, 12:12 PM
Replies: 8
Views: 1,460
Posted By david s poole
that's classified i could tell you but then i'd...

that's classified i could tell you but then i'd have to kill you.
Forum: Tech Help 10-28-2010, 12:09 PM
Replies: 3
Views: 689
Posted By david s poole
check the vacuum check valves in front of the...

check the vacuum check valves in front of the fusebox you will find a loose conection for a least one vac line two options 1 replace valve 2 cut back silicon line and push back on to valve tightly.
Forum: Tech Help 10-26-2010, 10:52 AM
Replies: 13
Views: 938
Posted By david s poole
give me a call so i don't need to type all the...

give me a call so i don't need to type all the instructions.---4696880422.
Forum: Tech Help 10-18-2010, 02:08 PM
Replies: 6
Views: 1,489
Posted By david s poole
not necessarily if double fuse version.

not necessarily if double fuse version.
Forum: Tech Help 10-18-2010, 10:21 AM
Replies: 16
Views: 1,787
Posted By david s poole
i vote for motor mounts.

i vote for motor mounts.
Forum: Tech Help 10-18-2010, 10:18 AM
Replies: 27
Views: 2,503
Posted By david s poole
i would second the textar pads,i have used them...

i would second the textar pads,i have used them in preference to factory for years.
Forum: Tech Help 10-18-2010, 10:15 AM
Replies: 6
Views: 1,489
Posted By david s poole
check the fuse[s] on the ovp relay.the...

check the fuse[s] on the ovp relay.the description you gave is perfect for limp home on that car.
Forum: Tech Help 10-16-2010, 11:33 AM
Replies: 10
Views: 836
Posted By david s poole
take a test light and disconnect the ground cable...

take a test light and disconnect the ground cable from battery,now put test light between cable and battery ground--if light comes on you have a draw.remove fuses one by one until light goes out.now...
Forum: Tech Help 10-14-2010, 05:33 PM
Replies: 8
Views: 831
Posted By david s poole
i don't believe that the original was metal.it...

i don't believe that the original was metal.it was plastic and aluminum.the early yrs of the 126 had issues with neck braking on top tank so were sometimes replaced with metal,but the behr will...
Forum: Tech Help 10-14-2010, 05:29 PM
Replies: 1
Views: 1,872
Posted By david s poole
brake light switch,use only oem.switch is located...

brake light switch,use only oem.switch is located on upper side of brake pedal meaning you will need to pull down panel under steering wheel to gain access.simple release,there is a toggle pce that...
Forum: Tech Help 10-12-2010, 01:22 PM
Replies: 5
Views: 5,823
Posted By david s poole
it's probably the blower motor regulator[that...

it's probably the blower motor regulator[that porcupine looking thing thats mounted beside the blower motor.you can check it because it provides the ground wire to the blower.just get a big solid...
Forum: Tech Help 10-12-2010, 01:12 PM
Replies: 11
Views: 1,822
Posted By david s poole
that switch in W will make car start in second...

that switch in W will make car start in second with a necessary solid push of the kickdown switch to get to first.in the other mode it will allow kick to first with the acc pedal without hitting...
Showing results 1 to 30 of 500

 
Forum Jump


All times are GMT -4. The time now is 10:47 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2022, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2018 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page