Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Search Forums

Showing results 1 to 30 of 500
Search took 0.11 seconds.
Search: Posts Made By: larry perkins
Forum: Mercedes-Benz Used Parts For Sale & Wanted 05-18-2011, 01:48 PM
Replies: 13
Views: 1,074
Posted By larry perkins
pictures

pictures are too dark to see the injector and valve seat area.
larry perkins
Forum: Diesel Discussion 04-15-2011, 07:03 PM
Replies: 25
Views: 1,338
Posted By larry perkins
battery

bill,batterys will drive one up the wall,have you tried another battery that will start a diesel car. i fool with batteries a lot,even auto zone can check to see if the unit has the capacity for...
Forum: Diesel Discussion 04-15-2011, 06:40 PM
Replies: 25
Views: 1,338
Posted By larry perkins
compression

let us in on the secret compression values.
larry perkins
Forum: Diesel Discussion 04-04-2011, 07:09 PM
Replies: 12
Views: 1,100
Posted By larry perkins
put this one to bed

ok forum,the ip housing was indeed cracked,welded up the crack,installed the mb square gasket,test drove and no leaks.
i do suggest that the crack in the housing was a direct result of the ip rear...
Forum: Diesel Discussion 03-12-2011, 03:43 PM
Replies: 2
Views: 491
Posted By larry perkins
fuel line 606

forum, i seem to need another assist,am taking the ip off a 1997 e300diesel,the newer type of fuel line connector has me stumped,i slid the little white clip in as far as i could get it to slide with...
Forum: Diesel Discussion 03-10-2011, 11:08 AM
Replies: 12
Views: 1,100
Posted By larry perkins
mystery leak found

ok forum,better keep a good check going on the brace at the rear of those diesel injection pumps.
havent got it off yet but it sure looks like the bolts for the rear brace to block worked loose and...
Forum: Diesel Discussion 03-08-2011, 08:18 AM
Replies: 27
Views: 1,932
Posted By larry perkins
mph

ok,sorry for the scare on the vac pump,ball bearings are too small, they came from the check system(ball and spring) inside the piston oiler.
i do always look at the bearings inside the vac...
Forum: Diesel Discussion 03-08-2011, 08:03 AM
Replies: 27
Views: 1,932
Posted By larry perkins
mph

first thing that poped out to me was the two ball bearings,believe they had to come from the bearing in side the vac pump.
larry perkins
Forum: Diesel Discussion 03-07-2011, 08:07 PM
Replies: 27
Views: 1,932
Posted By larry perkins
wow

better throw in a new vac pump.(got to run,will have more time to look later)
larry perkins
Forum: Diesel Discussion 03-06-2011, 07:05 PM
Replies: 12
Views: 1,100
Posted By larry perkins
ok about to give up

i would bet that there was a molded gasket to begin with,look at the picture in the parts break down.
ok i can remove and install the ip bottom plate in 45 minutes,ask me how? from practice,have had...
Forum: Diesel Discussion 03-06-2011, 10:23 AM
Replies: 27
Views: 1,932
Posted By larry perkins
windage tray

its hard to see the pump screen in the picture but one should be able to inspect the oil pan for signs of scuffing around the pump pick up area to determine if any loose parts have been there.(if...
Forum: Diesel Discussion 03-04-2011, 02:25 PM
Replies: 12
Views: 1,100
Posted By larry perkins
injection pump

bob,good idea, will do,just thought that others could have run into the same problem and as i couldnt find anything in the forum post just thought it would be a decent subject.
the origional...
Forum: Diesel Discussion 03-04-2011, 12:26 PM
Replies: 12
Views: 1,100
Posted By larry perkins
injection pump

forum,would anyone have a parts source for the injection pump used on the 603 engine?
the number on the pump is pes6m556320rs178.
heres my problem,i got a pump that seeps motor oil from the plate...
Forum: Diesel Discussion 03-02-2011, 04:52 PM
Replies: 28
Views: 2,854
Posted By larry perkins
prechamber

win,better have a contract on the loan out,maybe a few cases beer,if the slotted collar is too tough it will distort the tool. i had some from hitmans #18 head that i had to install threaded rod same...
Forum: Diesel Discussion 02-26-2011, 10:39 AM
Replies: 47
Views: 3,838
Posted By larry perkins
sleeve removal

it takes an average of 3000psi to push the sleeve from the sleeve bore in these diesel engines,highest i have seen is 4000psi all read on the guage on the press. i use to pound um out with a 12...
Forum: Mercedes-Benz Used Parts For Sale & Wanted 02-23-2011, 11:25 AM
Replies: 2
Views: 474
Posted By larry perkins
617 engine

i have new,rebuilt and used,what are you looking for?
larry perkins lou ky
Forum: Diesel Discussion 02-21-2011, 04:21 PM
Replies: 28
Views: 1,377
Posted By larry perkins
brake switch

yep did replace the brake sw,didnt get lucky,symptoms didnt change. this was done within 2 weeks of owning the car.before installing the sw i took ohm readings and couldnt see any difference between...
Forum: Diesel Discussion 02-21-2011, 02:21 PM
Replies: 28
Views: 1,377
Posted By larry perkins
e300

i dipped my toe into a 96 e300 a few months back,man that traction control system keeps going into error,shut it down restart and there is a good 80% chance it will not go into error for a week or...
Forum: Mercedes-Benz Used Parts For Sale & Wanted 02-18-2011, 03:57 PM
Replies: 3
Views: 676
Posted By larry perkins
engine

would u want to specify,new,used(minor to major).
larry perkins lou ky
Forum: Mercedes-Benz Used Parts For Sale & Wanted 02-10-2011, 07:19 PM
Replies: 0
Views: 479
Posted By larry perkins
tool

wtb countersink tool 601589006600
this is the tool for resurfacing the prechamber sealing area,603 diesel
larry perkins lou ky 15027276903
Forum: Diesel Discussion 02-06-2011, 08:51 AM
Replies: 12
Views: 803
Posted By larry perkins
engine install

jeff,i put everything on the engine including the tranny,my key is to use a chain jack (come-a-long) between the front lift and the hook used to lift the engine,that way you can keep adjusting the...
Forum: Diesel Discussion 01-28-2011, 12:09 PM
Replies: 7
Views: 717
Posted By larry perkins
noise

rs,my experience with that noise is a loose shock on the belt tensioner system. a good way to check is to take a hammer handle ,hold the metal part and place the handle with a little pressure on the...
Forum: Diesel Discussion 01-10-2011, 08:31 AM
Replies: 4
Views: 753
Posted By larry perkins
blower

what happens when u just turn on the defroster?
Forum: Diesel Discussion 12-18-2010, 03:06 PM
Replies: 1
Views: 461
Posted By larry perkins
engine code

auto zone should b able to pull the obd11 code.
Forum: Diesel Discussion 12-15-2010, 10:51 AM
Replies: 16
Views: 1,190
Posted By larry perkins
mm

i just had the drivers side replaced,tell tell was when in reverse the engine had a heavy rumble ,vibrated the entire car.
car is 96 300 diesel
larry perkins lou ky
Forum: Diesel Discussion 12-15-2010, 10:06 AM
Replies: 13
Views: 888
Posted By larry perkins
glow plug

you need to post the vehicle thats in question
Forum: Tech Help 12-11-2010, 11:58 AM
Replies: 1
Views: 506
Posted By larry perkins
can we compare notes,1987 300td wagon

hey guys,has anyone got notes on the current draw for the 87 wagon while at rest with nothing turned on? i get 73 to 75 ma with good digital meter.
larry perkins lou ky
Forum: Mercedes-Benz Used Parts For Sale & Wanted 12-07-2010, 07:22 PM
Replies: 5
Views: 545
Posted By larry perkins
oops

602 pistons and rods
Forum: Mercedes-Benz Used Parts For Sale & Wanted 12-07-2010, 07:20 PM
Replies: 5
Views: 545
Posted By larry perkins
pistons

one more thing, i can use the 602 3.5 liter pistons
Forum: Vintage Mercedes Forum 12-05-2010, 07:46 PM
Replies: 5
Views: 735
Posted By larry perkins
glow plug hook up

correct me if i am wrong, the old style glow plugs are designed to be hooked in series,each plug just gets a couple volts to operate ,the later pensil type are designed to operate in parallel,getting...
Showing results 1 to 30 of 500

 
Forum Jump


All times are GMT -4. The time now is 08:06 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2018 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page