Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help




Go Back   PeachParts Mercedes-Benz Forum > Search Forums

Showing results 1 to 30 of 395
Search took 0.03 seconds.
Search: Posts Made By: 89-300ce
Forum: Tech Help 11-24-2018, 03:58 PM
Replies: 8
Views: 1,572
Posted By 89-300ce
Following up on some of those numbers led me down...

Following up on some of those numbers led me down a rabbit hole of resellers and non Bosch parts that where only referencing themselves to known Bosch numbers (have to read the fine print).

I...
Forum: Tech Help 11-24-2018, 11:11 AM
Replies: 8
Views: 1,572
Posted By 89-300ce
I wonder if there are any differences between...

I wonder if there are any differences between these EHA's used on different models. They appear physically the same. Perhaps different initial calibration to be able to start the car in order to fine...
Forum: Tech Help 11-23-2018, 05:10 PM
Replies: 8
Views: 1,572
Posted By 89-300ce
Resurrecting an old thread. I'm also...

Resurrecting an old thread.

I'm also finding Bosch 2437020007, 11373DH , and W0133-1715115 cross referenced to #3 437 010 040 on parts sites.

Is there a cross reference site for bosch part...
Forum: Tech Help 10-06-2016, 09:34 AM
Replies: 5
Views: 622
Posted By 89-300ce
Thanks. That's exactly what I was looking for. ...

Thanks. That's exactly what I was looking for.

Jorg
Forum: Tech Help 10-05-2016, 05:30 PM
Replies: 5
Views: 622
Posted By 89-300ce
Did you mean that if I only disconnect the...

Did you mean that if I only disconnect the non-adjustable ends I shouldn't need a wheel alignment?

Thanks.

Jorg
Forum: Tech Help 10-05-2016, 05:08 PM
Replies: 5
Views: 622
Posted By 89-300ce
W124 rear knuckle/bearing carrier removal?

I've got a noisy rear wheel bearing and will attempt to remove the knuckle assembly and bring it to a machine shop to R&R the wheel bearing.

From the PelicanParts tech article

"You do not...
Forum: Off-Topic Discussion 11-22-2013, 10:28 AM
Replies: 30
Views: 1,225
Posted By 89-300ce
That's uncanny.

That's uncanny.
Forum: Tech Help 10-11-2012, 04:57 PM
Replies: 2
Views: 735
Posted By 89-300ce
Thanks! Jorg

Thanks!

Jorg
Forum: Tech Help 10-11-2012, 03:27 PM
Replies: 2
Views: 735
Posted By 89-300ce
M103 Pistons

I can't seem to find m103 pistons from on line vendors. Are there any other sources or is it Mercedes only?

Jorg
Forum: Tech Help 11-10-2011, 11:54 AM
Replies: 5
Views: 1,766
Posted By 89-300ce
Because I didn't know to order them. Jorg

Because I didn't know to order them.

Jorg
Forum: Tech Help 11-10-2011, 11:48 AM
Replies: 5
Views: 1,766
Posted By 89-300ce
One or more of the injectors is leaking making...

One or more of the injectors is leaking making for a hard start to no start condition due to flooding at about 15 minutes after shut down. Up to about 10 min. after shut down is fine and after about...
Forum: Tech Help 11-10-2011, 10:17 AM
Replies: 5
Views: 1,766
Posted By 89-300ce
Found the info. If anyone else is...

Found the info.

If anyone else is interested. Seems they just pull apart.

Jorg
Forum: Tech Help 11-09-2011, 11:30 PM
Replies: 5
Views: 1,766
Posted By 89-300ce
M103 Fuel injector disassembly

Just received my new injectors and I can't quite figure out how to change the black insulator over onto the new injector. It rotates freely but doesn't seem to want to pull off.

Jorg
Forum: Tech Help 01-04-2011, 09:55 AM
Replies: 9
Views: 1,966
Posted By 89-300ce
I remember when climate control systems used...

I remember when climate control systems used cables connected to flaps. When you wanted it warmer you moved the lever to the red and if you wanted it colder you moved it to the blue. If that didn't...
Forum: Tech Help 01-02-2011, 11:42 AM
Replies: 9
Views: 1,966
Posted By 89-300ce
Thanks for that info. I will check for 70-80psi...

Thanks for that info.
I will check for 70-80psi with compressor off and proceed from there.

Jorg
Forum: Tech Help 01-01-2011, 01:41 PM
Replies: 9
Views: 1,966
Posted By 89-300ce
Thanks for the info. Since I don't have access...

Thanks for the info.
Since I don't have access to guages at the moment I will jump the switch as a test.

Jorg
Forum: Tech Help 12-31-2010, 04:32 PM
Replies: 9
Views: 1,966
Posted By 89-300ce
124 a/c pressure switch operation?

Hello,

My a/c compressor isn't engaging. I've jumpered the terminals at the Klima module and got the compressor to engage. I checked the continuity between the two spade terminals of the...
Forum: Off-Topic Discussion 02-22-2010, 10:34 AM
Replies: 41
Views: 2,365
Posted By 89-300ce
My wife and I traveled across the country on a 74...

My wife and I traveled across the country on a 74 H2. Clip-ons, Bassanis, and a port job. It would surge violently at 60-70mph cruise so you could never keep a constant speed. It sounded like the...
Forum: Tech Help 10-01-2009, 10:23 AM
Replies: 1
Views: 482
Posted By 89-300ce
300ce Center Vent?

Ok. I was pretty convinced that I would be pulling the dash to replace my pods because I was getting a rythmic tap, tap, tap, noise from the center vent in cooling mode. Another poster had the same...
Forum: Tech Help 08-07-2009, 11:09 AM
Replies: 1
Views: 633
Posted By 89-300ce
Weak Spark!

After parking my 89-300ce for about a month I couldn't get it started. The plugs where fouled so I installed some fresh ones. Still no start. When I checked for spark it was weak and yellow. I dried...
Forum: Off-Topic Discussion 05-28-2009, 09:48 AM
Replies: 22
Views: 779
Posted By 89-300ce
Auto dark comes in handy when you are under a...

Auto dark comes in handy when you are under a car.

Jorg
Forum: Off-Topic Discussion 05-27-2009, 10:00 AM
Replies: 22
Views: 779
Posted By 89-300ce
I have a 220v Hobart mig that I'm happy with....

I have a 220v Hobart mig that I'm happy with. Sheetmetal guys seem to prefer Miller, something about a softer arc, and if I recall the 110v was preferred for sheet metal. For anything other than...
Forum: Tech Help 05-20-2009, 10:52 PM
Replies: 7
Views: 2,206
Posted By 89-300ce
Thanks Acky, While I had the vac pump...

Thanks Acky,

While I had the vac pump disconnected for diagnosis of the vacuum loss I could still lock and unlock the drivers door with the key. Of course with the vac pump disconnected the...
Forum: Tech Help 05-20-2009, 10:10 PM
Replies: 7
Views: 2,206
Posted By 89-300ce
I just checked and you are correct, they torched...

I just checked and you are correct, they torched through the vac line to the filler cap. Fixed.

The key still doesn't operate the passenger door lock but I suppose that is unrelated. I'm not...
Forum: Tech Help 05-20-2009, 09:43 PM
Replies: 7
Views: 2,206
Posted By 89-300ce
Yes, that is the area that they worked on....

Yes, that is the area that they worked on. Wouldn't the key still operate the passenger door though?

Jorg
Forum: Tech Help 05-20-2009, 09:07 PM
Replies: 7
Views: 2,206
Posted By 89-300ce
w124 door lock actuator

The car is a 1989 300ce

I had my car in to a body shop for a minor paint touch-up on the passenger side rear wheelhousing.

When I received the car back I noticed the door lock vacum pump...
Forum: Off-Topic Discussion 04-20-2009, 10:12 AM
Replies: 127
Views: 7,729
Posted By 89-300ce
When I think about the layout, crash safety not...

When I think about the layout, crash safety not withstanding, I think they nailed the future car concept.

Jorg
Forum: Off-Topic Discussion 12-02-2008, 10:28 AM
Replies: 19
Views: 722
Posted By 89-300ce
Doc said "Not likely". I tried and it started...

Doc said "Not likely".
I tried and it started climbing almost immediately. I bought a personal monitor.

Jorg
Forum: Off-Topic Discussion 12-02-2008, 10:01 AM
Replies: 19
Views: 722
Posted By 89-300ce
I droped 40 lbs, one drink a day, lowered my...

I droped 40 lbs, one drink a day, lowered my caffeine, no salt, take my medicine regularely, watch what I eat, and run 2 mi. five times a week. I feel great. Haven't had a headache in over a year....
Forum: Tech Help 10-20-2008, 08:54 PM
Replies: 3
Views: 1,904
Posted By 89-300ce
Sudden w124 rear suspension noise

My 89 300ce has had a occasional minor clunk from the passenger rear suspension when going over bumps for quite some time now. On Sunday I decided to have a look.

I removed the shock and took...
Showing results 1 to 30 of 395

 
Forum Jump


All times are GMT -4. The time now is 12:38 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2018 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page