Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Search Forums

Showing results 1 to 17 of 17
Search took 0.01 seconds.
Search: Posts Made By: Michael Haven
Forum: Tex-Mex (TX, OK, NM, Mexico) 01-08-2007, 06:26 PM
Replies: 15
Views: 8,139
Posted By Michael Haven
Wow!. Thanks Dave. That may be the best "oops" I ...

Wow!. Thanks Dave. That may be the best "oops" I have ever seen.
No hard feelings on my part, as I said before, I didnt understand how there was a complaint. Glad to know there isn't. As you said,...
Forum: Tex-Mex (TX, OK, NM, Mexico) 01-08-2007, 12:33 PM
Replies: 15
Views: 8,139
Posted By Michael Haven
If this is Mr Petrick, I have a copy of the parts...

If this is Mr Petrick, I have a copy of the parts list used on your repair right here. I would be happy to discuss all the parts used and why, but after 5 years ???
Exactly what parts do you feel...
Forum: Tex-Mex (TX, OK, NM, Mexico) 01-08-2007, 12:28 PM
Replies: 15
Views: 8,139
Posted By Michael Haven
Well thats quite a statement. Would you care to...

Well thats quite a statement. Would you care to elucidate, or even identify yourself?
Forum: Tech Help 12-12-2000, 09:07 PM
Replies: 2
Views: 870
Posted By Michael Haven
Door panel R&R

remove screws from armrest. Pry out plastic cup behind inside release handle. remove that screw. Remove screws from chrome U at latch. remove screw from rear upper trim at glass.The seat switch...
Forum: Tech Help 12-12-2000, 08:56 PM
Replies: 10
Views: 3,036
Posted By Michael Haven
91 420sel dome lamp inop from driver door

The fault is in the warning module. It also has the headlight on buzzer citcuit in it. It gets damaged when the left frt puddle lamp falls out and the door closes on it. the module fries itself to...
Forum: Tech Help 12-07-2000, 11:12 PM
Replies: 1
Views: 880
Posted By Michael Haven
300 e int light prob

The timer is in the lamp assembly. replace it.
Forum: Tech Help 12-07-2000, 11:08 PM
Replies: 1
Views: 1,260
Posted By Michael Haven
TAch at diag connector

Patsy , sometimes it can be read with a good DVOM, ie. a Fluke 88. This is hit or miss. The bosch tool is a faster capture rate and always works.And has a dedicated connector, so this may be fuzzy....
Forum: Tech Help 12-07-2000, 10:55 PM
Replies: 4
Views: 801
Posted By Michael Haven
2 possibilities come to mind. The plug bodies...

2 possibilities come to mind.
The plug bodies have melted at the bulbs, losing the ground circuit connection.Very common with hi watt bulbs.
or the lamp failure module is open circuit.
Forum: Mercedes-Benz Used Parts For Sale & Wanted 08-24-2000, 01:56 PM
Replies: 0
Views: 870
Posted By Michael Haven
excellent condition, ice blue metallic,paint code...

excellent condition, ice blue metallic,paint code 348. new list is over 9000$!! sell for 2000$ 281-579-8885

------------------
Michael Haven CMAT,CMM,L1
MPH Automotive Services
16510 Park Row...
Forum: Tech Help 06-03-2000, 04:30 PM
Replies: 7
Views: 1,144
Posted By Michael Haven
check the small breather hose on side of valve...

check the small breather hose on side of
valve cover,about the size of your index finger,they split down the side.
p/n 103 094 00 82-- only a few bucks.


------------------
Michael Haven...
Forum: Tech Help 04-24-2000, 08:00 PM
Replies: 3
Views: 648
Posted By Michael Haven
There is a lot of space under the false floor on...

There is a lot of space under the false floor on the right side . remove the carpets and have a look. I think it will fit there.

------------------
Michael Haven CMAT,CMM,L1
MPH Automotive...
Forum: Tech Help 04-24-2000, 07:57 PM
Replies: 2
Views: 1,179
Posted By Michael Haven
Panel removal is not difficult, there are many of...

Panel removal is not difficult, there are many of those snap in clips at the lower edge. use a putty knife or such to lever the clips. Then the panel is pulled straight up to release the tabs that...
Forum: Tech Help 04-24-2000, 07:50 PM
Replies: 2
Views: 1,490
Posted By Michael Haven
First let me say that the idle speed is not meant...

First let me say that the idle speed is not meant to be owner or shop adjusted.
But if it has been adjusted and runs ok warm, you might have a damper pin/screw thats in too far.Pin is gold colored...
Forum: Tech Help 04-06-2000, 10:29 AM
Replies: 25
Views: 9,296
Posted By Michael Haven
Hi Richard, I have used that product and really...

Hi Richard, I have used that product and really hoped it would work as described.
It sorta did.I offered it to my customers on a test basis. as the maker warranted that if it did not seal , they...
Forum: Tech Help 03-30-2000, 11:05 AM
Replies: 3
Views: 1,420
Posted By Michael Haven
Hi Ron you are describing a failed frt wheel...

Hi Ron you are describing a failed frt wheel speed sensors' symptoms exactly. It makes the abs unit think that the wheel has stopped turning. Thus engaging the anti-lock.
The home test is to check...
Forum: Tech Help 03-22-2000, 07:28 PM
Replies: 1
Views: 879
Posted By Michael Haven
The EGR on 84 us model 617 does not use a...

The EGR on 84 us model 617 does not use a switchover valve. It is temp and throttle position that regulate the vac to EGR.
The switchover valve on the firewall is for the boost enrichment, aneroid...
Forum: Tech Help 03-20-2000, 08:52 PM
Replies: 26
Views: 2,886
Posted By Michael Haven
<BLOCKQUOTE><font size="1" face="Verdana,...

<BLOCKQUOTE><font size="1" face="Verdana, Arial">quote:</font><HR>Originally posted by Mark Herzig:
When are you guys seeing replacements for the 603 300SDL?
<HR></BLOCKQUOTE>

Mark I like to...
Showing results 1 to 17 of 17

 
Forum Jump


All times are GMT -4. The time now is 12:54 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2022, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2018 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page