Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Search Forums

Showing results 1 to 30 of 109
Search took 0.03 seconds.
Search: Posts Made By: taaboo
Forum: Mercedes-Benz Used Parts For Sale & Wanted 12-11-2008, 09:36 AM
Replies: 49
Views: 3,216
Posted By taaboo
PM sent - THANKS Brian

PM sent -

THANKS

Brian
Forum: Mercedes-Benz Used Parts For Sale & Wanted 10-04-2008, 08:27 AM
Replies: 11
Views: 847
Posted By taaboo
PM sent - THANKS! Brian

PM sent -

THANKS!

Brian
Forum: Tech Help 07-11-2008, 12:36 PM
Replies: 3
Views: 692
Posted By taaboo
My experience with this issue on this vintage...

My experience with this issue on this vintage W124: fuel pump relay.

If it continues to worsen you can remove the relay and jumper the pins (don't have schematic in front of me right now) to...
Forum: Tech Help 02-11-2008, 10:20 PM
Replies: 1
Views: 588
Posted By taaboo
92 W124 Blower question - no voltage at plug

Looked at the pictures again, need to check at the firewall, not the plug end - will update later 8^)

Blower stopped. 7degF outside - great. 30A fuse OK, #7 fuse OK. Checked three prong...
Forum: Mercedes-Benz Used Parts For Sale & Wanted 11-28-2007, 10:52 AM
Replies: 3
Views: 554
Posted By taaboo
WTB Becker receiver for 91-93 W124

Friends -

Was getting the E2 code on my head unit (problem with receiver) and last weekend traced a large current draw that was draining my battery to the receiver. So right now it's unplugged. ...
Forum: Tech Help 11-23-2007, 03:08 PM
Replies: 2
Views: 500
Posted By taaboo
Hi Zeus - there is an old school analog phone...

Hi Zeus - there is an old school analog phone installed under the rear seat, but it is powered from under the fuse box, they attached the leads by screwing into one of the 25A circuits. I unplugged...
Forum: Tech Help 11-23-2007, 03:04 PM
Replies: 2
Views: 500
Posted By taaboo
SOLVED - 92 300TE - pulls 1A when off, draining battery

After a little more searching I found some threads on antenna and/or radio/amplifier causing problems. Disconnected amplifier, current draw dropped 600ma, the disconnected radio connector (module on...
Forum: Mercedes-Benz Used Parts For Sale & Wanted 07-09-2007, 09:42 AM
Replies: 4
Views: 512
Posted By taaboo
babymog: my 300TE has black partial leather...

babymog: my 300TE has black partial leather interior (1992), though at this point I would not have a problem with dying, price is the driver

jim16671836: PM me price/shipping info - the seat I'm...
Forum: Mercedes-Benz Used Parts For Sale & Wanted 07-07-2007, 02:08 PM
Replies: 4
Views: 512
Posted By taaboo
WTB W124 parts

Friends:

1992 300TE - looking for, in order of importance:

LH and RH turn signal markers
Center Vent
Third seat set-up

THANKS
Forum: Tech Help 01-25-2007, 11:15 AM
Replies: 9
Views: 2,188
Posted By taaboo
The a.i.r. pump seized on my 92 300TE and I...

The a.i.r. pump seized on my 92 300TE and I replaced it with one from mbpumps.com - I had great service from them, ymmv. Thought about going the shorter belt route but decided not to mess with that....
Forum: Tech Help 01-23-2007, 09:00 AM
Replies: 1
Views: 613
Posted By taaboo
Was W210 wagon available with SportLine?

Thinking of upgrading (?) in the next year or so from my W124's to a W210 wagon - were the wagons available with SportLine option or only the sedans?

THANKS

Brian
Forum: Tech Help 01-23-2007, 08:58 AM
Replies: 28
Views: 4,134
Posted By taaboo
THANKS everyone for your input, I passed on the...

THANKS everyone for your input, I passed on the W140 for now - really need to stay with the wagons for the foreseable future -

Brian
Forum: Tech Help 01-15-2007, 12:45 PM
Replies: 0
Views: 503
Posted By taaboo
Tried the search, need info on 300TE 3rd seat

Going to remove third seat and related stuff this week from a donor, and I know there was a post offering MB instructions to do this but I can't for the life of me find it in a search - any links to...
Forum: Mercedes-Benz Wheels & Tires 01-05-2007, 11:36 AM
Replies: 4
Views: 1,397
Posted By taaboo
Tires ok to use after sitting?

Friends -

Last summer I put some Nitto 460's on CLK rims on my 89 300TE. Some time later the transmission started flaking out (275K, not bad I guess) and the car has been sitting since.

I am...
Forum: Tech Help 01-05-2007, 11:29 AM
Replies: 28
Views: 4,134
Posted By taaboo
1998 W140 Probelm Areas

Friends -

There is a 1998 S320 for sale here at work I am really intrigued by - 71K, all records by MB shop, immaculate. Here's the deal - some expensive maintenance has been done (closing...
Forum: Tech Help 08-28-2006, 05:10 PM
Replies: 13
Views: 1,425
Posted By taaboo
On our 89 TE you have to pull the 'knob' that is...

On our 89 TE you have to pull the 'knob' that is pressed in when the door closes to fully release the seat - I'll bet that's what it it - look about halfway between the bottom and top of the door...
Forum: Mercedes-Benz Used Parts For Sale & Wanted 12-07-2005, 02:03 PM
Replies: 1
Views: 444
Posted By taaboo
WTB: 7-spoke CLK wheel

Darned potholes! I've got the 1998-2001(?) CLK 7-spoke wheels on my W124, and one is broken due, looking for a replacement -

THANKS

Brian in Indy
Forum: Tech Help 06-03-2005, 10:55 AM
Replies: 3
Views: 977
Posted By taaboo
W124 Rear Wheel Bearing R&R

Friends - left rear wheel bearing getting really noisy on our 1989 300TE. The manual doesn't seem to reference R&R of the bearing. Can this bearing be replaced with the wheel carrier on the car,...
Forum: Tech Help 04-19-2005, 09:24 AM
Replies: 14
Views: 2,273
Posted By taaboo
Thanks everyone, I'm going to grab a tech with a...

Thanks everyone, I'm going to grab a tech with a scope and check the reference sensor over lunch. JimF, I'll test the coil if the reference sensor checks out OK, may be worth replacing at 220K...
Forum: Tech Help 04-18-2005, 09:51 PM
Replies: 14
Views: 2,273
Posted By taaboo
On a DMM I'm getting 0.6VAC when cranking, book...

On a DMM I'm getting 0.6VAC when cranking, book says 1.5 but not sure the DMM can be directly compared?

Brian
Forum: Tech Help 04-18-2005, 09:13 AM
Replies: 14
Views: 2,273
Posted By taaboo
Thanks everyone, didn't have computer access this...

Thanks everyone, didn't have computer access this weekend.

So we are talking about the reference sensor at the rear of the engine, OK, that helps (the more expensive one of course).

When the...
Forum: Tech Help 04-15-2005, 12:12 PM
Replies: 14
Views: 2,273
Posted By taaboo
Thanks, that's what I've been gathering since...

Thanks, that's what I've been gathering since I've read some more posts. There is no CPS listed on FastLane, is it the reference sensor located at the crank or the one on the flywheel - IIRC one is...
Forum: Tech Help 04-15-2005, 10:01 AM
Replies: 14
Views: 2,273
Posted By taaboo
W124 dying at speed - O2 sensor question

Friends - 1989 W124 wagon, 220K, well maintained, new fuel relay and pumps/filter (relay had failed) and OVP (precautionary) recently.

Car is dying at speed and once or twice at idle. Like it's...
Forum: Tech Help 09-28-2004, 11:37 AM
Replies: 3
Views: 655
Posted By taaboo
THANKS everyone and Mercedesshop!

THANKS everyone and Mercedesshop!
Forum: Tech Help 09-27-2004, 12:15 PM
Replies: 3
Views: 655
Posted By taaboo
W124/M103 O2 Sensor R/R - Center console needs removed?

As I ponder this seemingly simple repair, I see the sensor wires go between the carpet and the center console - does the console need to be removed/loosened for this job?

THANKS in advance -
...
Forum: Tech Help 08-09-2004, 01:28 PM
Replies: 1
Views: 809
Posted By taaboo
If I understand your question, when the door...

If I understand your question, when the door shuts there is pin that gets pushed in by the door, on our 89 TE is has a black 'button' cap. Pull this out a bit while pulling the seat back forward.
...
Forum: Tech Help 06-14-2004, 07:13 PM
Replies: 168
Views: 41,843
Posted By taaboo
When you compare how the brake fluid looks, after...

When you compare how the brake fluid looks, after only a year, to new fluid, the answer is pretty obvious.

Brian
Forum: Tech Help 06-14-2004, 07:12 PM
Replies: 0
Views: 729
Posted By taaboo
Pressure bleeder - how to use on W124?

Every year I forget about this - when I connect my brake bleeder to our 89 300TE, it won't hold pressure - it vents through the "warning assembly" on top of the reservoir (where the two rubber caps...
Forum: Tech Help 06-09-2004, 02:42 PM
Replies: 0
Views: 761
Posted By taaboo
Need wheel bolt size

I come to the group on bended knee once again:

I need the lug bolt description for the lug bolts that came on early CLK cars (e.g. 1998 CLK320). I know these are ball seats (duh) but could really...
Forum: Mercedes-Benz Used Parts For Sale & Wanted 06-01-2004, 05:06 PM
Replies: 0
Views: 534
Posted By taaboo
WTB: early CLK lug bolts

Bought a set of CLK rims (the 5? spoke ones on the early 1998ish CLKs) for my 1989 W124 and it seems the current lug bolts are too long due to the differences in how the rims are dished. Anybody...
Showing results 1 to 30 of 109

 
Forum Jump


All times are GMT -4. The time now is 01:07 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2021, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2018 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page